|
manual abstract
• If no signal is found during this period, the tower icon will not appear and the clock will search again at 12:00 am the next night. • The radio-controlled time receiver is located on the bottom side of the projection alarm. When using the AC adaptor be sure to keep the adapter cord away from the bottom side of the unit as if the wire is too close it can cause weakened reception sensitivity. 5 II. PROGRAM MODE To enter the Program Mode hold down the “MODE/MIN” button for 3 seconds, until the time flashes in the top of the display. The Program Mode Guide is laid out in a manner that allows you to program each function separately, or you can follow the instructions entirely to program the projection alarm. Complete programming is usually done for the initial set-up, and will require you to skip step 1 and 2 of programming sections D and E. To exit the setting mode simply wait approximately 10 seconds for the projection alarm to automatically return to normal operation. A. PROGRAMMING SEQUENCE 1. Manual Time Display 2. Time Zone Setting 3. Daylight Saving Time On/Off B. FUNCTION BUTTONS There are 3 function buttons located on the front of the projection alarm and one on the top. The function buttons are labeled: AL/HOUR, light direction icon, MODE/MIN, and SNOOZE (the top bar). Mode Button (toggles between Alarm Button (also adjusts Display Direction indoor temp/hum and alarm the hours in time setting time. Also adjusts minutes in mode) time setting mode C. MANUAL TIME SETTING 1. Hold down the “MODE/MIN” button for 3 seconds, the time will flash in the Time LCD. 2. Press and release the “AL/HOUR” button to advance the hours and press and release the “MODE/MIN” button to advance the minutes. NOTE: “A.M.” or “P.M.” will be displayed to the left of the time to help identify the time. 3. Press and release the “SNOOZE” button to confirm the time setting and to advance to DST (Daylight Saving Time) setting. D. TIME ZONE SETTING 1. Hold down the “MODE/MIN” button for 3 seconds, the time will flash in the Time LCD. 2. Press and release the “SNOOZE” button to advance to the time zone selection. 3. In the indoor temperature/humidity section of the LCD the time zone will flash. 6 4. Press and release the “MODE/MIN” button to select the appropriate time zone. There are 24 time zones to choose from (based relative to the international time standard of GMT (“Greenwich Mean Time). NOTE: The U.S. time zones will show abbreviations as opposed to the numerical time zone indicator. For example Eastern Time will display “ET” when the Eastern Time Zone is selected 5. Press and release the “SET” button to confirm the time zone setting and to advance to the DST (Daylight Saving Time) setting. -4h Atlantic Time -5h Eastern Time (default setting) -6h Central Time -7h Mountain Time -8h Pacific Time -9h Alaskan Time -10h Hawaiian Time -11h, -12h Next two time zones West of HAW 0h Greenwich Mean Time -1h, -2h, -3h Three time zones West of GMT E. DST (DAYLIGHT SAVING TIME) SE...
Other models in this manual:Remote Control - WS-8158U-IT (139.33 kb)
Remote Control - WS-8418U-IT (139.33 kb)
Remote Control - WT-2100 (139.33 kb)
Remote Control - WT-2150A (139.33 kb)