Refer to the following Network connection method. 2-20-1. Connecting to a Dynamic IP (DHCP) Network You can attach the projector to your network by connecting it to the network through a modem that uses DHCP (Dynamic Host Configuration Protocol). When you use a DHCP modem, the modem automatically provides the IP address, subnet mask, gateway, and DNS server values that the projector needs to access the network. To connect to a DHCP network, follow these steps : 1. Connect the modem cable between the modem port on the wall and the external modem. 2. Connect a LAN cable between the external modem and the wired or wireless IP router. 3. Connect a LAN cable between the [LAN] port on the back of the projector and the wired or wireless IP router. 4. Turn on the projector, and then press the Menu button. 5. Select ^ ^ ^ ^ . 6. The projector automatically acquires the IP address, Subnet mask and Gateway. 0 To use the network function, must be set to . 0 If the IP address allotment from the DHCP server fails, turn off the external modem for more than 10 seconds, restart the modem, and then retry the connection. 0 For instructions on the setup and connection of the external modem and Router, refer to the user manual for each product. 0 You can connect the LAN cable from the modem directly to the projector, You do not need a router. 0 You can not use a manual connection-type ADSL modem because it is not a DHCP-type device. Make sure to use an automatic connection DHCP ADSL modem. 2-20 Installation and Connection 2-20-2. Connecting to a Static IP Network You can attach the projector to a network that uses a Static IP address, which corresponds to using a dedicated lease line. If your network uses Static IP addresses, you must get the IP address, subnet mask, gateway, and DNS server values from your Internet Service Provider (ISP), turn on the Network function in the projector's Menu, and then enter the values into the Network function manually. To connect to a Static IP address network, follow these steps : 1. Connect a LAN cable between the LAN port on the wall and a wired or wireless IP router. 2. Connect a LAN cable between the [LAN] port on the back of the projector and the wired or wireless IP router. 3. Turn on the projector, and then press the Menu button. 4. Select ^ ^ ^ ^ . 0 To use the network function, must be set to . 5. Press the Enter button.Use the ■Other models in this manual: Projectors - SP-L331 (2.8 mb) Projectors - SP-L351 (2.8 mb)
)
