Votes - 1, Average rating: 5
(
)
)
|
manual abstract
000-011_ES8078_7_6_5_EU 05.12.5 12:58 ページ 11
cleaning recharger securely (see
use for more than 6 months, the
AC outlet (see fig. 5). The shaver will
back and forth in the direction of your
fig. 13, 14, 15).
charge status lamp may not illumi-
be adjusted automatically to voltages
beard. You may gently increase the
2. Insert the appliance plug into the
nate for a few minutes after opera-
between 100-240V AC.
amount of pressure as your skin be-
socket (see fig. 16-1).
tion. It will eventually illuminate if
In some areas, a special plug adap-
comes accustomed to this shaver.
3. Firmly insert the adaptor into the
kept connected.
tor may be required.
Applying excessive pressure does
AC outlet (see fig. 16-2).
not provide a closer shave.
It will be adjusted automatically
The charge status lamp will glow
Pivot action selector
to voltages between 100-240V
when the shaver is being charged.
Using your shaver
(see fig. 7)
AC.
The battery capacity monitor will fully
Use the pivot action selector to
In some areas, a special plug
illuminate and the charge status lamp
Caution – The system outer foil is
choose the shaving mode, [soft]
adaptor may be required.
will blink after charging is completed
very thin and can be damaged if
(soft) and [lock] (lock) based on
4. Pull up the arm of the self-clean-
(see fig. 4 (A)).
handled improperly. Before each
your shaving preference.
ing recharger until it clicks (see
10 minutes after charging is com-
use, always check the foil for dam-
fig. 17-3).
The pivot action can be changed
pleted, the battery capacity monitor
age. To avoid personal injury, do
5. Remove the protective cap and
whether the switch is turned on or
will turn off and the charge status
not use if the foil or other parts of
set the shaver firmly onto the self-
off.
lamp will continue to blink (see fig. 4
the shaving head are damaged.
cleaning recharger until it clicks
(B)).
System outer foil
(see fig. 17-4).
Push the On/Off switch to turn the
You can fully charge the shaver in 1
(see fig. 8)
• The Self-cleaning recharger is
shaver on.
System outer foil has a slit blade (a)
set on the [Charge] (Charge)
hour if the LED display shows “low”.
between 2 foils (b). They move up
cource when the shaver is set on.
The battery capacity monitor indi-
If you push and hold the On/Off
and down independently to follow the
• Do not push the arm down-
cates the charge remaining in the
switch for more than 2 seconds, it
contours of your face.
wards.
battery in 3 levels (high/mid/low). The
will activate the turbo mode for
The slit blade catches and cuts
• Ensure that the outer foil does
unit can be used once or twice more
“sonic” vibration cleaning.
longer and lying hairs easily.
not get deformed or damaged
after “low” starts to blink. (Differs de-
(see “Cleaning your shaver with-
when placing the shaver into the
pending on usage.)
out the self-cleaning recharger”)
For wet shaving
self-cleaning recharger.
Shaving with “sonic” vibration may
Put a thin layer of shaving foam on
A full charge will supply enough
damage your skin. Please turn it
Note
your face which works as a lubricant.
power for approx. 14 shaves (3 min-
off and on again to deactivate the
Shaving foam is the most suitable
• Use the self-cleaning recharger in
utes per shave for a normal beard).
turbo mode.
among many other shaving aids (gel,
environments that do not exceed
You can always connect your shaver
soap, cream, etc.). Do not put a thick
ambient temperatures of 15 to
to the self-cleaning recharger or the
Do not place fingers on the On/Off
layer of shaving foam as it may af-
35 °C and humidity levels of 95%.
adaptor to maintain full battery ca-
switch during use.
fect shaver’s performance. If the
• If it is far below or over the appro-
pacity. This shaver cannot be over-
This may cause the shaver to stop
shaving head is clogged with foam,
priate temperature, the charging
charged.
during use or change it to the
time may extend, or the Self-clean-
simply rinse it under running water.
Before travelling, charge it fully for 1
“sonic” vibration cleaning mode.
ing recharger may not function.
hour if you will not be taking the adap-
Place your finger on the finger rest
Using the trimmer
• In particular, low temperature may
tor with you.
during use.
shorten the life span of the re-
(see fig. 9)
chargeable battery. In this case, the
Slide the trimmer handle up to open
Charging without self-
Hold the shaver at a right angle (90°)
charge status lamp blinks twice per
to your skin (see fig. 6). Start out
the trimmer.
second.
cleaning recharger
shaving by applying gentle pressure
Place the trimmer at a right angle to
• When charging the shaver for the
Connect the power cord to the
to your face. Stretch your skin with
your skin and move it downward to
first time or when it has not been in
shaver, and plug the adaptor to an
your free hand and move the shaver
trim sideburns.
11
...