Votes - 0, Average rating: 0
(
)
)
|
manual abstract
6225.p06-09EN 05.06.01 0:49 ページ7
Bit locking function
Battery charger···(I)
With the switch at off, the bit is
NOTE: When you charge the battery
locked in place, and the tool can be
pack for the first time, or after
used as a manual screw-driver - up
prolonged storage, charge it
to 14.7Nm (150kgf-cm, 130 in-lbs).
for about 24 hours to bring the
There will be a little play in the driving
batteries up to full capacity.
shaft, but this is not a malfunction. (Fig. 4)
EY0225
1. Plug the charger into an AC outlet.
Main switch (ON/OFF)···(C)
NOTE: Sparks may be produced
Push the upper half of the switch for
when the plug is inserted
forward rotation, or the lower half for
into the AC power
reverse rotation. (Fig. 5)
supply, but this is not a
problem in terms of safety.
Speed selector switch···(A)
2. Insert the battery pack firmly into
To suit the application of this tool,
the charger. (Fig. 9)
two different rotational speeds are
3. During charging, the charging
available. Depending upon use,
lamp will be lit.
either the high or low speed should
When charging is completed, an
be selected.
internal electronic switch will auto-
matically be triggered to prevent
LOW
200/min (RPM)
strong torque
overcharging.
HIGH
600/min (RPM)
less torque
B Charging will not start if the bat-
tery pack is warm (for example,
CAUTION: Check rotational speed
immediately after heavy-duty
selection before operating this tool. (Fig. 6)
operation). The orange standby
lamp will be lit until the battery
Main switch lock···(B)
cools down. Charging will then
After use, set the main switch lock at
begin automatically.
the lock position to prevent acciden-
4. When charging is completed, the
tal operation. (Fig. 7)
charging lamp will start flashing rapidly.
5. If a fully charged battery pack is
Battery pack (EY9025)···(E)
inserted into the charger again, the
charging lamp may light up and then
CAUTION
flash slowly. After several minutes,
1. Press the battery pack release
buttons on both sides and pull the
the charging lamp may flash quickly
pack away from the tool.
to indicate the charging is completed.
2. Charge the battery pack using the
6. If the charging lamp does not light
battery charger.
immediately after the charger is
3. After the charging has been complet-
plugged in, or if after the standard
ed, remove the battery pack from the
charging time the lamp does not go
charger and connect it to the tool.
off, consult an authorized dealer.
Disconnect the charger form the
NOTE:
power source when not in use. (Fig. 8)
• When a cold battery (of about 5°C
or less) is to be charged in a warm
Battery pack life
room, leave the battery in the room
The rechargeable batteries have a
for at least one hour and charge it
limited life. If operation time becomes
when it has warmed up to room
extremely short after recharging, replace
temperature. (Failing to do so may
the battery pack with a new one.
result in less than a full charge.)
NOTE: • Use under extremely hot or
• Cool down the charger when
cold conditions will reduce
charging more than two battery
operating capacity per charge.
packs consecutively.
CAUTION:
Battery Recycling
• Do not use power source from
For environmental protection and
an engine generator.
recycling of materials, be sure that it is
• Unplug the charger when not
disposed of at an officially assigned
in use.
location, if there is one in your country.
– 7 –
...Other models in this manual:
Other - EY6225CQ (345.17 kb)