Votes - 0, Average rating: 0
(
)
)
|
manual abstract
The procedures are similar for all versions of NetWare. Procedures that are specific to a NetWare version are noted when necessary. Copy the cda1000.dsk and aspitran.dsk files from the Adaptec Array1000SA Family Manager Set driver diskette into the server ’s startup directory (e.g., c:\nwserver, c:\server.312) on your hard disk drive. Note : For NetWare 3.12, the cda1000.dsk and aspitran.dsk files are located in the \netware\v3_1x subdirectory on the diskette; for NetWare 4.11, the files are in \netware\v4_xx. If necessary, modify the lo ad command line in the startup.ncf so that the proper path to the driver is specified. The correct syntax to load the cda1000.dsk driver is load [ pathname]cda1000 Note : If you unload cda1000.dsk driver, you must also unload cioams.nlm. When you load cda1000.dsk driver again, you must also load cioams.nlm. If cioams.nlm is not unloaded when you unload cda1000.dsk, your system may work erratically. InstallingSoftware ona Novell NetWareServer Netware Installation and Configuration Notes Larger Than 4 GByte Arrays When installing NetWare on an array 4 GBytes or larger, the install program erroneously reports that the DOS partition is too small. It however does allow to continue installation. Ignore this error message. Unloading cda1000.dsk When running Adaptec CI/O Management Software, do not unload cda1000.dskwhile iomgr.nlmis still loaded. Unstable behavior may result. Configuring a Windows Client to Manage Netware Servers To run the WinRPC for SPX system, the Windows NetWare environment should be patched to the latest level from Novell. The patches should be at the “DOSUP9” and “WINUP9” level, or greater. Novell patches are available on CompuServe and the Novell FTP and web site on the internet. The following table lists the NetWare client components that have been successfully tested. Do not use versions older than the version listed below: NetWare Component Version lsl.com 9/10/93, 2.05 ipxodi.com 10/7/93, 2.12 netx.exe 11/17/93, 3.32 netware.drv 10/27/92, 2.00 vnetware.386 11/19/93, 1.04 vipx.386 1/19/94, 1.13 nwcal ll s.dll 11/2/93, 4.04 nwipxspx.dll 11/2/93, 4.04 AAA-130SA Series Installation and Hardware Guide Installing the TIRPC Communications Module The TIRPC communications module must be installed before you install the Adaptec CI/O Management Software. The module allows communications between the server and remote clients. Follow the instructions below for the version of NetWare installed. NetWare 3.12 1 Insert the Adaptec CI/O Management Software CD-ROM in your CD-ROM drive. 2 From the NetWare colon prompt (:), type the following and press Enter: load install 3 Select Product Options from the Installation Options Menu. 4 Press the key. 5 Enter the path to the CD-ROM (do not include the backslash). 6 Select NetWare 3.x TIRPC Runtime and Configuration Files. (TIRPC must be installed in the sys:system directory only.) NetWare 4.11 1 Insert the Adaptec CI/O Management Software CD-ROM in yo...
Other models in this manual:Other - AAA-131SA (1.22 mb)