Votes - 3, Average rating: 3.7 ( )

Manafacture: Bushnell File size: 414.98 kb File name: Language of manual:

Any return made under this warranty must be accompanied by the items listed below: 1) A check/money order in the amount of $10.00 to cover the cost of postage and handling 2) Name and address for product return 3) An explanation of the defect 4) Proof of Date Purchased 5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address listed below: IN U.S.A. Send To: IN CANADA Send To: Bushnell Outdoor Products Bushnell Outdoor Products Attn.: (Atencion) Repairs (Reparaciones) Attn.: (Atencion) Repairs (Reparaciones) 9200 Cody 25A East Pearce Street, Unit 1 Overland Park, Kansas 66214 Richmond Hill, Ontario L4B 2M9 For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In Europe you may also contact Bushnell at: Bushnell Outdoor Products Gmbh European Service Centre MORSESTRASSE 4 D- 50769 KOLN GERMANY Tel: +49 (0) 221 709 939 3 Fax: +49 (0) 221 709 939 8 This warranty gives you specific legal rights. You may have other rights which vary from country to country. ©2011 Bushnell Performance Optics Before returning for repair, consult the Trouble Shooting Table below. TROUBLE ShOOTING TABLE If unit does not turn on - LCD does not illuminate: • Depress power button. • Check and if necessary, replace battery. If unit powers down (display goes blank when attempting to power the laser): • The battery is either weak or low quality. Replace the battery with a good quality alkaline battery. Heavy Duty alkaline batteries are NOT recommended. There is no reset button to clear last range reading before ranging another target: • The last range reading does not need to be cleared before ranging another target. Simply aim at the new target using the LCD’s reticle, depress the power button and hold until new range reading is displayed. If target range cannot be obtained: • Make sure LCD is illuminated. • Make sure that the power button is being depressed • Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the target) that emit and receive the laser pulses. • Make sure unit is held steady while depressing power button. FCC NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separati...

Download now

Please, enter two numbers from picture: