Votes - 3, Average rating: 4.3
(
)
)
|
manual abstract
Load the glue sticks into the back of the gun. 2: Press trigger several times until the glue stick is firmly set into the inner tube. 3: Allow the glue gun to warm up for approximately 5 minutes. 4: Squeeze trigger until glue flows from the nozzle. 5: Glue need not be spread. Press surfaces together within 15 seconds. Use of clamps or other holding devices is not necessary. Clean surfaces for best bonding. 6: Unplug glue gun when finished. No clean up required. Never pull the glue stick out the back of the gun. Use 5/i6" glue sticks only. CAUTION: Hot melt glue gets hot! Nozzle area temperature reaches 380°. If accidental contact should occur do not try to remove the glue. Put in cold water immediately. Manufactured in China for Woodstock International, Inc. Visit our website @ woodstockinternational.com...