Votes - 3, Average rating: 4
(
)
)
|
manual abstract
For Best Results, Read This Manual Before Installing Your New Sears Bugwacker Full One Year Warranty If, within one year from the date of purchase, this electronic insect killer fails due to a defect in materials or workmanship, Sears will repair it free of charge. Warranty service is available by simply returning your unit to the nearest Sears store or Service (_enter throughout the United States. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Sears, Roebuck and Co. Department 698/731A Sears Tower, Chicago, IL 60684 RULES FOR SAFE USE OF BUGWACKER ® Install the unit 6 to 8 feet above the ground to prevent children,. pets and wildlife from coming in contact with it. 2 Use grounded 115/120 volt AC outlet and 3-wire grounded extensioncord. For permanent installation check local codes and consultan electrician or authoritative instruction book _ bf e ore instaIli ng. _ 3. Never place fingersor hands,or insert any objects into the _ unit while it is connected to electrical outlet. Always disconnect the unit before servicing, handlingor disassemblingunit. @ 5. Clean dead insects from bottom of unit frequently to reduce risk of fire. Connect unit to properly grounded outlet only. Keep extension cord connections dry and off the ground. t Don't abuse power cord. Never carry unit by cord or yank it to disconnect from receptacle. Keep power cord from heat, oil and sharp edges. ASSEMBLY 1. Remove Bugwacker from carton and check to make sure no transportation damages have occurred. The carton should contain the following: 1 -Bugwacker electronic bug killer 2 -Plastic bag containing the following: 1 -gold colored hanging ring 1 -threaded fitting Save your carton and the cardboard fillers for storing your Bugwacker during the off-season. 2. Refer to Illustration A. A. Assemble the threaded fitting (2) into gold col- I ored hanging ring (1). B. Screw hanging ring and fitting into hole in hood and tighten until snug. INSTALLATION 1. Your Bugwacker should be hung or post mounted from a pole, bracket or post mounted from a pole, bracket or post (available as accessories)at a height of 6 to 8 feet above the ground. This is the flying altitude for many types of light-sensitive insects and will increase the unit's effectiveness. 2. Plug electrical cord into a three-wire grounded outdoor extension cord. Lamp will emit a soft bluish glow. Note: A momentary arc may occur across the high voltage grids when first plugged in. This-is due to the surge of electricity. It will stop and resume normal operation. 3. Refer to Illustration B. Placement of the unit is 0 o 00 ° essential to its maximum INSECT O effectiveness. Since the O ARE, 0 o Bugwacker is a luring device, it should not be t INSECT KILLER located in the area in tended for human activity. 25-50 FT It should be placed 25 to 1 50 feet away, and between the source of insects (i.e. woods, lowlands, etc.) arid the areas to be protected. ILLUSTRATION B If additional light is required in the area of human activity, it should be provided by yellow light. Studies have shown that insects are less attractive to yellow light. 4. Sears Bugwackers are ideal for backyards, pools, patios, summer homes, trailer homes, campgrounds, marinas, outdoor recreational areas, gardens or anywhere flying insects are a problem. EXTENSION CORDS Outdoor extension cords must be used with this Bug wacker. Use extension cords marked SJW-A, or SJTW-A and tagged "suitable for use with outdoor appliances". The electrical rating of the extension cord must be as great as the electrical rating of your Bugwacker. Use only three-wire extension cords which have three- prong grounding type plugs and three-pole receptacles which accept the products plug. Appropriate extension cords and devices for retaining an extension cord connection to the Bugwacker power cord are available at your local Sears store. Replace or repair damaged cords. GROUNDING INSTRUCTIONS Your Bugwacker is equipped with an appropriate three- conductor cord and three-prong grounding type plug to fit the proper grounding type receptacle. To reduce the risk of electrical shock, plug must be plugged into an appropriate outlet that is properly installed and grounded Your Bugwacker has a grounding plug that looks like the plug shown below and is intended for use on a circuit that has an outlet as shown below. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt as to whether proper grounding exists. OPERATION 1. General: Your new Sears Bugwacker is designed to attract light-sensitive flying insects with black light, and to kill them cleanly without the use of poisons, fogs, sprays or chemicals. Insects are drawn to the fluorescent bulb, and killed by an electrostatic grid when they pass through it. Thd insects do not have to actually touch the grid to be killed. The moisture in their bodies is enough to trigger the arc, so t...
Other models in this manual:Other Home Accessories - BugWacker 557-5199 (412.88 kb)