Votes - 3, Average rating: 3.7
(
)
)
|
manual abstract
Carefully insert two front extension tubes (F) with attached brackets facing out. All four extension legs should be at their lowest position and locked with four height adjustment knobs (H). Set base aside. Front extension tube Figure 4 Figure 3 Place tabletop (B) with preferred side facing down on carpeted or protected floor. Place supplied cardboard template on board surface with edge of template at front edge of board. Left and right edges of template should be an equal distance from each side of the tabletop. Using a VS" drill bit, gently drill W deep holes where marked on the template. Remove template. Wrap masking tape W" from drill bit end to determine drilling depth. Take care to drill only W deep to avoid drilling through and destroying tabletop surface. Carefully turn table assembly upside down and place on top of tabletop. Align holes in front leg extension brackets (F) with holes in tabletop (see Figure 4). Fasten all 5/s" screws (I) and tighten securely. Use care not to overtighten and strip. \ 5/s" Screws Figure 5 Carefully return table assembly to the upright position. Adjust 0 tabletop to desired height using height adjustment knobs (H You’re finished and your table is ready to use (see Figure 5). WORKMASTER MODELS: WM48-3-XB WM48-4-XB WM60-3-XB WM60-4-XB WM72-3-XB WM72-4-XB WORKMASTER JR. MODELS: WMJ-3-XB WMJ-4-XB WMJ48-3-XB WMJ48-4-XB WMJ-3-WBR WMJ-4-WBR WMJ-3-XBR WMJ-4-XBR ©2007 ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722 Phone: 860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896 LIT-A7010 5/07...
Other models in this manual:Other Home Accessories - WorkMaster (151.2 kb)