Votes - 4, Average rating: 4.3
(
)
)
|
manual abstract
Briggs & Stratton does not approve of or authorize such uses. ENGINE INSTALLATION [1] Do not attempt to install this engine if you do not have the appropriate tools and knowledge of small engine installation procedures. Use only Briggs & Stratton parts. Contact your Authorized Service Dealer for assistance. [2] Do not modify the engine in any way without Briggs & Stratton factory approval. Any such modification is at the owner.s sole risk. [3] If the exhaust system on the old engine was supplied by the equipment manufacturer, you must transfer the exhaust system and related components (original muffler and related pipes, brackets, clamps, and shields) to the new engine. All components must be in good condition. [4] WARNING Install muffler (and muffler deflector if used) so outlet points away from operator, fuel tank, and equipment, and so muffler heat will not damage or deform engine and components. [5] WARNING Ensure all fuel lines and fittings are properly assembled and do not leak. Replacement parts must be the same model as the original. [6] WARNING Ensure all wiring, including safety switches and engine shut-off components are completely installed and functioning properly. [7] Set engine speed to equipment manufacturer.s specification. Refer to equipment manufacturer.s manual. Do not tamper with governor springs, or other parts that will increase engine speed above specification. [8] WARNING All engine parts, including fuel cap, spark plug, muffler, air cleaner, and covers and guards for drive components (gears, belts, shafts, couplings, etc.) must be in place before attempting to start engine. [9] WARNING If engine is installed on walk behind lawn mower, all mower components, including cutting blade, must be correctly installed before attempting to start engine. [10] WARNING When working on the engine or equipment, remove spark plug wire from spark plug. For electric start, remove negative wire from battery. [11] WARNING Do not check for spark with spark plug removed. Use Briggs & Stratton spark tester #19368. ENGINE OPERATION WARNING When adding fuel: Turn engine off and let engine cool at least 2 minutes before removing gas cap. Fill fuel tank outdoors or in well-ventilated area. Fill tank to about 1 inch below lowest portion of neck to allow for fuel expansion. Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition sources. WARNING When starting engine: Remove all external equipment/engine loads. Wait until spilled fuel is evaporated. Start engine outdoors. Pull cord slowly until resistance is felt, then pull rapidly. If engine floods, set choke to OPEN/RUN, place throttle in FAST and crank until engine starts. WARNING When operating equipment: Do not tip engine or equipment at angle which causes gasoline to spill. Run engine outdoors. Do not run in enclosed area, even if doors or windows are open. Do not choke carburetor to stop engine. ...
Other models in this manual:Other Home Accessories - 25540 (665.58 kb)