Votes - 4, Average rating: 4.3 ( )

Manafacture: Axor File size: 131.56 kb File name: Language of manual:

to 7:00 p.m. Eastern Time Saturdays 8:00 a.m. to 4:00 p.m. Eastern Time Turn off hot and cold water supplies before beginning. CAUTION VALVE INSTALLATION DRAIN INSTALLATION SERVICE 1 6 2 4 LEDGE RUBBER WASHER BRASS WASHER LOCKNUT VALVE BODY 5/16'' MIN. ESCUTCHEON RUBBER RING LOCKNUT SPOUT EXTENSION CLIP CLIP LIFT ROD EXTENSION THUMBSCREW ACTUATOR ROD CARTRIDGE SCREEN SPRING CLIP STOP WASHER RETAINER RUBBER WASHER RUBBER GASKET SINK Insert BASE or SPOUT shank through center hole of SINK, making sure RUBBER GASKET is properly positioned. SPOUT OR BASE ASSEMBLY Assemble RUBBER WASHER, RETAINER, and LOCKNUT onto threads of SPOUT from underside of SINK. Insert LIFT ROD through SPOUT (or BASE) and slot of RETAINER. Align SPOUT and tighten LOCKNUT. Be sure slot in BRASS WASHER is positioned to the rear as shown. Prepare TUBE and TEE ASSEMBLY to fit available VALVE location. If necessary, cut and/or bend TUBING carefully. Make sure tube bend is close to the TEE so that it will not effect the compression joint at the VALVE. Place RUBBER RING into ESCUTCHEON and screw ESCUTCHEON onto VALVE BODY until snug against internal stop. Tighten LOCKNUT to secure VALVE position. Attach COUPLING to TEE and tighten. ACTUATOR ROD TAIL PIECE TEST INSTALLED FAUCET5 Remove AERATOR. With handle in OFF position, turn on water supplies and check all connections for leaks. Operate both handles to flush water lines thoroughly. Check spout mounting and hose connections for leaks. Operate LIFT ROD and check DRAIN for leaks. Turn handles into OFF position and replace AERATOR. Apply a bead of PUTTY around the underside of DRAIN PLUG flange and insert DRAIN PLUG into SINK drain hole. Hold DRAIN PLUG firmly to prevent turning, and assemble the GASKET, WASHER, and LOCKNUT from underneath the SINK. Insert GASKET into COUPLING and attach COUPLING to DRAIN PLUG. Align COUPLING so that the ACTUATOR ROD faces rear of SINK and tighten LOCKNUT to secure position. Unscrew ACTUATOR NUT and withdraw the ACTUATOR ROD. Drop STOPPER into DRAIN PLUG with the OFFSET SQUARE SLOT in line with ACTUATOR ROD opening. Reassemble ACTUATOR ROD. Make sure ROD is inside offset square slot of the stopper. Tighten ACTUATOR NUT. Insert threaded end of TAILPIECE into lower end of COUPLING. Connect other end of TAIL PIECE to the TRAP. Slide EXTENSION onto ACTUATOR ROD and secure with CLIP. Slide EXTENSION onto LIFT ROD and tighten THUMBSCREW. Adjust LIFT ROD stroke for proper opening and closing of the stopper. To change direction of handle rotation, proceed as follows: Turn valve to OFF position. Remove INSERT and HANDLE SCREW. Slip HANDLE with ADAPTER off. Remove SPRING CLIP. Lift STOP WASHER, turn 90° and replace. Replace SPRING CLIP. Replace ADAPTER, HANDLE, SCREW, and INSERT. AERATOR may accumulate dirt causing distorted and reduced water flow. Remove AERATOR and rinse clean. If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90°. Plastic SCREEN in CARTRID...

Download now

Please, enter two numbers from picture: