Votes - 0, Average rating: 4
(
)
)
|
manual abstract
CONSUMER: Retain this manual for future reference. US WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLO- SION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. FOR YOUR SAFETY: What to do if you smell gas: • DO NOT light any appliance. • DO NOT touch any electrical switches. • DO NOT use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow your gas suppliers instructions. • If your gas supplier cannot be reached, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. FOR USE ONLY WITH DECORHEATERS. ATIVE TYPE UNVENTED ROOM DO NOT BUILD A WOOD FIRE. WARNING: IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE INJURY OR PROPERTY DAMAGE. REFER TO THIS MANUAL. FOR ASSISTANCE OR ADDITIONAL INFORMATION CONSULT A QUALIFIED INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER. WARNING: DO NOT BURN WOOD OR OTHER MATERIAL IN THESE APPLIANCES. CAREFULLY REVIEW THE INSTRUCTIONS SUPPLIED WITH THE DECORATIVE TYPE UNVENTED ROOM HEATER FOR THE MINIMUM FIREPLACE SIZE REQUIREMENT. DO NOT INSTALL THE APPLIANCE IN THIS FIREBOX, UNLESS THIS FIREBOX MEETS THE MINIMUM DIMENSIONS REQUIRED FOR THE INSTALLATIONS. This is an unvented gas-fired heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to Combustion and Ventilation Air Section, Page 3. Due to high temperatures, the appliance should be located out of traffic and away from furniture or draperies. Do not place clothing or other materials on or near this appliance. IMPORTANT: READ AND UNDERSTAND THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING YOUR UNVENTED ROOM HEATERS. These heaters are manually controlled. Models These heaters are manually controlled. Models TABLE OF CONTENTS VF4000-CMN-2 and VF4000-CMP-2 feature a Pipe compound General Information ......................... page 2 gas valve incorporating a millivolt operating system. Building Supplies Should Include: Inventory ......................................... page 2 Tools and Building Supplies ............ page 2 A spark ignition system (piezo) allows the heater Framing materials Installation Applications .................. page 2 pilot gas to be lit without the use of matches or Wall finishing materials batteries and permits operation of the heater Caulking materials (noncombustible) Important Safety Information .......... page 2 during a power outage. Fireplace surround materials Codes .............................................. page 3 Combustion and Ventilation Air ....... page 3 These heaters are fitted with a specially de- Installation Applications signed pilot (ODS) which responds to the Location of Fireplace ....................... page 4 amount of oxygen available in the room and 1. Fireplace built into a framed wall. Clearances ....................................... page 5 shuts the heater off before the oxygen level Preinstallation .................................. page 5 drops below 18%. The pilot can be relit only 2. Fireplace installed with oak surround and/ when fresh air is available. Refer to the Com or platform (Refer to the SUR-5/6 unfin- Installation – Built-In ....................... page 5 bustion and Ventilation Air section. ished oak veneer surround installation in- Connecting Gas Line ........................ page 6 structions, P/N 903593). The VF4000 Series Unvented Room Heaters may be built into a framed wall, or installed in an Gas Pressure Check......................... page 6 Check the inventory list to be sure that you have Electrical Wiring – Optional Blower . page 7 optional oak surround. all the necessary parts in usable condition. Also Finished Wall Details ....................... page 8 check for concealed damage. This heater has been tested to the standards of ANSI Z21.11.2 unvented heaters. Installation – Surround .................... page 8 Log Assembly .................................. page 8 IMPORTANT SAFETY INFORMATION Flame Appearance ........................... page 9 Do not install these unvented room heaters in INSTALLER: PLEASE LEAVE THESE INSTRUC- a bedroom or bathroom as all units exceed Optional Equipment ......................... page 10 TIONS WITH THE OWNER. maximum allowable BTU/Hr input of 10,000. Forced Air Kit ................................... page 10 Operation and Care .......................... page 11 OWNER: PLEASE RETAIN THESE INSTRUC- Inventory TION FOR FUTURE REFERENCE. Cleaning and Servicing .................... page 11 Unvented Gas Fireplace Replacement Parts .......................... page 11 IMPORTANT: BEFORE STARTING YOUR Gas connection fittings HEATER INSTALLATION, READ THESE INSTAL Accessories/Components ................ page 12 I...