|
manual abstract
(15.2 cm) clearance on the right side to the nearest vertical wall or cabinet for bag removal. • Note: This compactor is designed for built-in applications only. TOOLS REQUIRED • Level • Phillips Screwdriver • Pliers • Gloves • Measuring Tape PARTS SUPPLIED • 6 mounting screws (located in the literature package) • 2 countertop retaining brackets • 2 side mounting clips 3 ADVANCE PLANNING CLEARANCES • You should be able to fully open the compactor drawer. Six inches (15.2 cm) is required on the right side of the compactor for bag removal. • Allow 23 inches (58.4 cm) in front of the compactor to remove the drawer. • This compactor is designed as a built-in appliance only. It may be located in any convenient space under a countertop. DO NOT OPERATE FREE-STANDING. • The compactor may be installed beneath countertops of stone or other materials that will not accept screws. No trim kit is required. The compactor must be securely installed in a cabinet that is firmly attached to the house structure. Weight on the compactor drawer could cause the compactor to tip and result in injury. Never allow anyone to climb, sit or hang on the compactor drawer. MODELS WITH A CUSTOM DRAWER PANEL Models ZCGP150 II and GCG1700 II The custom drawer panel and custom handle of your choice should be secured to the compactor before installation begins. A template with instructions and installation hardware is provided with those models. For planning purposes, you may order the template in advance. Order Pub. No. 31-30597. Complete panel installation instructions are included on the template. CUSTOM PANEL SIZE REQUIREMENTS: Maximum panel weight is 12 LBS (5.4 kg). 29-5/16. (74.5 cm) 14-7/8. (37.8 cm) 3/4. (1.9 cm) Thick Custom Panel 4 Installation Preparation ELECTRICAL REQUIREMENTS GROUNDING REQUIREMENTS WARNING! FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before beginning installation. Do not use an extension cord or adapter plug with this appliance. • The power supply cord and plug should be brought to a separate 15 or 20 ampere branch circuit single grounded receptacle. The outlet box should be located within reach of the 36" (91.4 cm) power cord. • This appliance must be supplied with 120V, 60Hz and connected to an individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. • If the electrical supply does not meet the above requirements, call a licensed electrician before proceeding. IMPORTANT: Observe all governing codes and ordinances. WARNING! The improper connection of the equipment grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt that the appliance is properly grounded. • Electrical Ground is REQUIRED on this compactor. • DO NOT ground to a gas pipe. • DO NOT change the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician. • DO NOT have a fuse in...
Other models in this manual:Other Kitchen Appliances - Built-In Compactors GCG1500 BB (714.37 kb)
Other Kitchen Appliances - Built-In Compactors GCG1500 WW (714.37 kb)
Other Kitchen Appliances - GCG1580 SS, GCG1500 BB, GCG1500 WW, GCG1700 II*, ZCGS150 SS, ZCGP150 II* (714.37 kb)
Other Kitchen Appliances - Built-In Compactors GCG1700 II (714.37 kb)