Votes - 3, Average rating: 4.3 ( )

Manafacture: FoodSaver File size: 316.09 kb File name: Language of manual:

The Drip Tray fits inside the Vacuum Channel (J) and is removable, making cleanup easy when small amounts of liquids are inadvertently pulled into Vacuum Channel during vacuum process (see FoodSaver Reference Guide for Appliance can be used without Drip Tray. tips on preventing this). QS.825_845_GSS_v3.1 4/30/04 3:47 PM Page 5 Tips for Successful Vacuum Packaging For more usage tips and safety information, please refer to the FoodSaver Reference Guide or visit our website at Sealing a Bag Make sure you’ve placed the bag in the proper place. When making a bag from a roll, make sure end of cut piece is on Sealing Strip (L), not over rubber gasket (M) or in Vacuum Channel (J). Prevent moisture or liquid from being pulled into the Vacuum Channel or trapped in the seal. Either pre-freeze moist foods such as raw meat for 1-2 hours before vacuum packaging, or place a folded paper towel between food and end of bag to absorb excess liquids. Just be sure to leave at least 3 inches Removing Air from a Bag Make sure you’ve placed the bag in the proper place. When vacuuming and sealing a bag, make sure open end of bag is inside Vacuum Channel (J). Check for wrinkles in the bag along the Sealing Strip. Wrinkles in seal may cause leakage and allow air to come back into bag. Check for wrinkles in bag along Sealing Strip (L) before closing lid and vacuum packaging. If you find wrinkles after sealing bag, simply cut bag open and vacuum package again. between paper towel and end of bag so that bag seals properly with paper towel inside. Make sure the Seal Control Switch (G) is set to Vacuum and Seal or to Vacuum and Extended Seal. Make sure you give appliance time to cool down. Wait at least 20 seconds between seals. Under very heavy usage, appliance will shut off automatically to prevent overheating. If it does, wait 20 minutes to allow appliance to cool off. If motor runs for more than 30 seconds without stopping, you may need to adjust bag and try again. If you are making the initial seal on a piece of bag material with two open ends, make sure bag is placed on Sealing Strip, not on black rubber gasket. If you are vacuum packaging with a bag, make sure open end is placed down inside Vacuum Channel and make sure Accessory Hose (A) is not attached. If you are vacuum packaging with an accessory, check Accessory Hose in appliance lid and in accessory to ensure a tight fit. Also make sure Seal Control Switch (G) is set to Vacuum and Seal or Vacuum and Extended Seal. Tips QS.825_845_GSS_v3.1 4/30/04 3:47 PM Page 6 Tips for Successful Vacuum Packaging General Tips 1. Vacuum packaging is NOT a substitute for the heat process of canning. Perishables still need to be refrigerated or frozen. 2. For best results, use FoodSaver Bags, Canisters and Accessories. 3. During the vacuum packaging process, small amounts of liquids, crumbs or food particles can be inadvertently pulled into Vacuum Channel, clogging the pump and damaging your appliance. To prevent this, follow these tips: a. For moist and juicy foods such as raw meats: Freeze first and avoid overfilling bags. You can also place a folded paper towel inside top of bag, but below seal area, before vacuum packaging. b. For soups, sauces and liquids: Freeze first and avoid overfilling bags. Or, use a canister in refrigerator. c. For powdery or fine-grained foods: Avoid overfilling bags or use a canister. You can also place a coffee filter or paper towel inside before vacuum packaging. d. If your appliance features a Drip Tray, empty it after each use. 4. To avoid overfilling, always leave at least 3 inches of bag material between bag contents and top of bag. Then leave at least one additional inch of bag material for each time you plan to reuse bag. (continued) 5. Do not create your own side seams for a FoodSaver Bag. These bags are manufactured with a special side seam, which is sealed all the way to the outer edge. 6. To prevent wrinkles in seal when vacuum packaging bulky items, gently stretch bag flat along Sealing Strip before you close lid. 7. If you are unsure your bag was sealed properly, simply reseal bag about 1.4 inch above first seal. 8. When you are vacuum packaging items with sharp edges (dry spaghetti, silverware, etc.), protect bag from punctures by wrapping item in soft cushioning material, such as a paper towel. You may want to use a canister or Mason jar instead of a bag. 9. When using accessories, remember to leave one inch of space at top of canister or container. 10.Pre-freeze fruits and blanch vegetables before vacuum packaging for best results. See pages 2-3 of FoodSaver Reference Guide for more information. p Copyright © 2004 Tilia, Inc. All rights reserved. This material may not be reproduced or redistributed in any fashion without the express written consent of Tilia, Inc. FoodSaver, GameSaver and the Freshness Shield logo are trademarks or registered trademarks of Tilia Int’l, Inc. in the United States and other countries. All other trad...

Download now

Please, enter two numbers from picture: