Reviews
Download now
If you are unable to understand the Warnings, Cautions or Instructions, contact a healthcare professional, dealer or technical personnel before attempting to use this equipment - otherwise, injury or damage may occur. • All four leg tips MUST be in contact with shower/tub floor at all times. • ALWAYS inspect the shower chair to ensure that it is properly positioned and stable before using. DO NOT use if shower chair is wobbly or unstable. • Ensure that the snap buttons fully protrude through the
DO NOT return products to our factory without our prior consent. C.O.D. shipments will be refused; please prepay shipping charges. LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR FAILURE TO ADHERE TO THE ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY TO SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STORAGE; OR PRO
• Ensure that the snap buttons fully protrude through their respective adjustment holes. • Check leg tips for rips, tears, cracks or wear. If any of these conditions exist, replace leg tips IMMEDIATELY. • Users with limited physical capabilities should be supervised or assisted when using the shower chair. • The shower chair is not to be used as a transfer bench, transfer device or climbing device. • Exercise caution when assembling the chair to avoid pinching. • After ANY adjustments, repair or
Put the shower chair on its side on a flat, stable surface. 2. Pressthesnapbuttonsonthebacksupporttubesandslidethe back support tubes into the back support brackets on the leg frame until both snap buttons are fully engaged inside the holes in the back support brackets. NOTE: Two audible “clicks” will be heard. Installing/Adjusting the Leg Extensions NOTE: For this procedure, refer to FIGURE 1 and FIGURE 2. FIGURE 1 Assembling the Shower Chair 1. Install the leg extension onto the leg (FIGURE 1)
2. Press the snap button and slide leg extension up or down to Leg Extension desired adjustment hole (FIGURE 2). 3. Ensure the snap button protrudes fully through the adjustment holes of the leg extension. Height Adjustment NOTE: There will be an audible click when the snap button fully engages. Holes 4. Repeat STEPS 1 .3 for the other legs. Snap Button NOTE: Make sure that all four legs are adjusted to the same height. Snap Button Back Support Brackets FIGURE 2 Installing/Adjusting the Leg Exte