Votes - 2, Average rating: 4.5
(
)
)
|
manual abstract
To unlock the dishwasher after it has been locked, touch the LOCK pad twice within 3 seconds. The light above the LOCK pad will turn off. DELAY HOURS Delays the start of a wash cycle for up to 8 hours. (on some models) RESET Touch RESET to cancel options. (timer models) START/RESET Touch START/RESET one time to start dishwasher cycle. Touch START/RESET a second time to pump out (electronic models) and then turn off the dishwasher. Do not touch START/RESET more than one time unless you intend to end the cycle. 4 ge.com Control Settings Cycle Chart Model Cycle Water Usage (gal.) Cycle Time (min.) GSD1100 Hot Start Option1 Heavy Wash Normal Wash Rinse Only Plate Warmer 2.5 7.0 5.7 2.2 0.0 10 120 117 53 40 HDA1100 ADW1100 Hot PreWash Option1 Normal Wash Drying 2.5 5.7 0.0 10 117 40 GSD1300 GSD2100 GSD2101 Hot Start Option1 Heavy Wash Normal Wash Light Wash Rinse Only Plate Warmer 2.5 7.0 5.7 4.5 2.2 0.0 10 120 117 113 53 40 HDA2100 Hot PreWash Option1 Heavy Wash Normal Wash Water Saver Rinse Only Drying 2.5 7.0 5.7 4.5 2.2 0.0 10 120 117 113 53 40 HDA3500 Hot PreWash Option1 Heavy Wash Normal Wash* Water Saver* Rinse Only* Plate Warmer 2.5 7.0 5.7 4.5 2.2 0.0 12 118 118 114 53 40 GSD2300 GSD2301 GSM2200 Hot Start Option1 Pots & Pans Normal Wash* Light Wash* Rinse Only* Plate Warmer 2.5 7.0 5.7 4.5 2.2 0.0 12 118 118 114 53 40 GSD2700 Hot Start Option1 Heavy Wash Normal Wash* Rinse Only* Plate Warmer 2.5 7.0 5.7 2.2 0.0 12 118 118 53 40 GSD3300 Hot Start Option1 Pots & Pans Normal Wash* Rinse Only* Plate Warmer 2.5 7.0 5.7 2.2 0.0 12 118 118 53 40 GHDA350 Hot Start Option1 Pots & Pans Heavy Wash Normal Wash* Light Wash* Rinse Only* Plate Warmer 1.3 8.2 7.0 5.7 3.4 2.2 0.0 3 103 103 103 95 42 33 GSD4000 Pots & Pans Heavy Wash Normal Wash China/Crystal Rinse Only 8.8 7.5 5.7 6.3 1.3 112 108 105 80 3 1 Hot Start Option adds water amount and cycle time shown when selected. * Normal Wash button should be pushed to run this cycle. NOTE: Not all models have every cycle listed. Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions 5 6 About the dishwasher control panel Consumer Support Troubleshooting Tips Operating Instructions Safety Instructions You can locate your model number on the left tub wall just inside the door. Throughout this manual, features and appearance may vary from your model. Please match the control panel for your unit to a similar control panel below. Operation of models with cycle dial ge.com Rinse Only For rinsing partial loads that will be washed later. Do not use detergent. Make sure HEATED DRY is not selected. Slowly turn the Dial to RINSE ONLY. 13 Be sure the door is unlatched. 4 Latch the door to start the cycle. 2 Plate Warmer or Drying For warming clean dishes and serving plates. This cycle will take approximately 39 minutes. Load clean dishware to be warmed. 1 Slowly turn the Dial to PLATE WARMER or Select HEATED DRY ON. 4 DRYING. 2 Be sure the door is unlatched. 35 Latch the door to start the cycle. Hot Start or Hot Prestart Option Preheats wash water to the correct temperature. Select the HOT START or HOT PRESTART Slowly turn the Dial to HOT START or 13 cycle and any other option on the push HOT PRESTART. button pad. 4 Latch the door to start the cycle. Be sure the door is unlatched. 2 Short Wash or Light Wash or Water Saver For quickly washing loads of everyday dishes with light to medium soils that have not dried on. Be sure the door is unlatched. 3 Latch the door to start the cycle. 1 Slowly turn the Dial to SHORT WASH, 2 LIGHT WASH or WATER SAVER. Start Delay (on some models) The START DELAY will allow you to delay the start time of any cycle automatically up to 6 hours. Be sure the door is unlatched. Slowly turn the Dial to the desired time. 13 The CYCLE ON light will come on. Select the wash cycle and option you want. 4 Latch the door to start the cycle. 2 Start (Models with a Dial) Slowly turn the Dial to the START or ON position, or the selected cycle. Don’t turn it past the START, ON or cycle position; you could accidentally miss a prewash. There is a time delay between start-up and water fill so you will not hear any wash action right away. Latch the door to begin the cycle. 7 Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions Operating Instructions Safety InstructionsConsumer Support Troubleshooting Tips Operation of electronic models (model GSD4000 Only) Using the Dishwasher Door The door must be closed and locked into place to select a LOAD SELECTION or an OPTION. 1 If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the 2 door is closed and latched into place. Start Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60 seconds later the wash action begins. NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher is loaded and the door latch is in the locked posit...