Votes - 3, Average rating: 4
(
)
)
|
manual abstract
Installation and service must be performed by a qualified technician. If the power supply cord is damaged, it must be replaced by a dealer or Authorised Service Centre or a similar qualified trades person in order to avoid a hazard. Ensure the DishDrawer® is secured to adjacent cabinetry using the brackets provided. Failure to do so may result in an unstable product, which may cause damage or injury. Do not operate this appliance if it is damaged, malfunctioning, partially disassembled or has missing or broken parts, including a damaged power supply cord or plug. Do not store or use petrol, or other flammable vapours and liquids in the vicinity of the DishDrawer®. Connect to a properly rated, protected and sized power supply circuit to avoid electrical overload. Make sure that the power supply cord is located so that it will not be stepped on, tripped over or otherwise subject to damage or stress. Do not install or store the DishDrawer® where it will be exposed to temperatures below freezing or exposed to weather. Do not use an extension cord or a portable electrical outlet device (e.g. multi-socket outlet box) to connect the DishDrawer® to the power supply. Maintenance Disconnect the appliance from the power supply before any cleaning or maintenance. Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in this user guide. We recommend that you call an Authorised Service Agent. Keep the floor around your appliance clean and dry to reduce the possibility of slipping. Keep the area around/underneath your appliance free from the accumulation of combustible materials, such as lint, paper, rags and chemicals. When cleaning the underside of the filter plate, care must be taken on the sharp outer edge to avoid the risk of cut type injuries. Safety and warnings Important safety instructions Important! Under no circumstances should you open the drawer whilst the DishDrawer® is in operation. Operational Always press the button to pause and wait until you hear the three additional beeps before opening the drawer. The DishDrawer® must be used with the motor assembly, filter plate, drain filter and spray arm in place. When disconnecting the appliance pull the plug rather than the power supply cord or junction of cord to avoid damage. Take care when loading the DishDrawer® not to load dishware items so they prevent the lid from properly sealing with the drawer. Items should be placed so they do not protrude above and/or forced into the drawer, otherwise a service call may result. Household appliances are not intended to be played with by children. Children or persons with a disability which limits their ability to use the appliance, should have a responsible person instruct them in its use. The instructor should be satisfied that they can then use the appliance without danger to themselves or their surroundings. Close supervision is necessary if this appliance is used by or near children. Do not allow children to play inside, on or with this appliance or any discarded appliance. If a dishwasher cleaner is used, we would strongly recommend a wash programme with detergent should be run immediately afterward, to prevent any damage to the DishDrawer®. The DishDrawer® is designed for washing normal household utensils. Items that are contaminated by petrol, paint, steel or iron debris, corrosive, acidic or alkaline chemicals are not to be washed in the DishDrawer®. If the DishDrawer® is not being used for long periods of time, turn the electricity and water supply to the DishDrawer® off. Do not pour detergent or rinse aid into the salt reservoir. The detergent or rinse aid will destroy the water softener. Do not operate your appliance by means of an external timer or separate remote-control system. Controls (models with no LCD) If you have a double DishDrawer®, each drawer has its own controls and can run independently of the other. Power button The button turns the DishDrawer® on or off. Opening the drawer will automatically turn the DishDrawer® on for 30 seconds. To end a wash programme in mid cycle, press the button. Any water in the DishDrawer® will be pumped out. Start/Pause button The button starts a wash programme. Press the button to pause or restart the DishDrawer® during a wash programme. When paused, wait for three beeps before opening the drawer. Forcing the drawer open while in mid cycle may cause damage or injury. Delay start The button also sets the Delay start feature which can delay the start of a wash programme from 1 to 12 hours. To activate Delay start 1 Press and hold the button until the light above the button turns orange (or purple, depending on your model). 2 Continue holding the button down until the desired delay time has been reached. The DishDrawer® will emit audible ‘beeps’ as you hold the button down, each beep indicates another hour delay. 3 The DishDrawer® will start once the delay time has elapsed and the drawer is closed. To cancel Delay ...