Votes - 0, Average rating: 0
(
)
)
|
manual abstract
– Switch on the main switch (. The display of the last selected programme flashes. This programme runs if no other programme button h is pressed. The expected programme duration is indicated on the numerical display @. – Close the door. The programme starts running. en Optical display while the programme is running * * depending on model While the programme is running, a light spot shines on the floor under the appliance door. Do not open the dishwasher door until the light point is no longer visible on the floor. If the appliance is installed at eye-level, with flush furniture front, the light point is not visible. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display @. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). Timer programming * * depending on model You can delay the start of the programme in 1 hour steps up to 19 hours. – Switch on the main switch (. – Press the timer programming button 8 until the digital display @ jumps to ‚oe. – Keep pressing the timer programming button 8 until the required time is displayed. – To delete the preselected starting time, press the button 8 until ‹oe is indicated on the digital display @. You can change your programme selection at any time until the programme starts. End of programme The programme has ended when the value ‹ is indicated on the numerical display @. The end of the programme is also indicated by an acoustic signal. This function can be changed as follows: – Open the door. – Hold down programme button 3 and switch on the main switch (. – Release both buttons. The programme button 3 flashes and the factory-set value . (half-loud) lights up on the numerical display @. To change the setting: – Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of „ has been reached, the display jumps back to ‹ (off). – Switch off main switch (, the set value is saved. – Close the door. Switching off the appliance Short time after the end of the programme: – Open the door. – Switch off the main switch (. – Turn off the tap (not applicable if Aqua- Stop fitted). – Remove the utensils when they have cooled down. a=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme – Open the door. – Switch off the main switch (. The LEDs go out. The programme is saved. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. – To continue the programme, switch on the main switch ( again. – Close the d...
Other models in this manual:Dishwashers - SRV45T23EU/36 (1.4 mb)
Dishwashers - SRV45T23EU/38 (1.4 mb)
Dishwashers - SRV45T23EU/41 (1.4 mb)
Dishwashers - SRV45T23EU/44 (1.4 mb)