Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 2.7 mb File name: Language of manual:

Do not allow children to play with or operate the appliance. Keep children away from detergents and rinse aid. These may cause chemical burns in the mouth, throat and eyes or asphyxiation. Keep children away from open dishwasher. The water in the rinsing compartment is not drinking water and could contain detergent residue. Ensure that children do not place fingers in the tablet collecting tray 24 . Small fingers could become caught in the slots. If the appliance is installed at eye-level, ensure when opening and closing the door that children are not caught or crushed between the appliance door and the cupboard door situated below. Childproof lock (door lock) The description of the childproof lock is at the back in the envelope. Damage The appliance may be repaired and opened up by a technician only. To do this, disconnect the appliance from the power supply. Pull out the mains plug or switch off the fuse. Turn off the tap. en Disposal Make redundant appliances unusable to prevent subsequent accidents. Dispose of the appliance in an environmentally friendly manner. Warning Children could become locked in the appliance (risk of suffocation) or find themselves in other dangerous situations. Therefore: Pull out the mains plug, sever and dispose of the power cord. Destroy the door lock so that the door can no longer be closed. Getting to know your appliance Diagrams of the control panel and the interior of the appliance can be found in the envelope at the front. Individual positions are referred to in the text. Control panel 1 2 3 4 5 6 7 8 9 10 11 12 ON/OFF switch Programme buttons ** Digital display Display “Check water supply” Salt refill indicator Rinse-aid refill indicator Timer programming display Time delay Additional options ** START button Door Opener Display window ** Number depending on model Appliance interior 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 Interior light * Top basket Knife shelf * Top spray arm Tablet collecting tray Intake opening Blow opening (Zeolith container) Bottom spray arm Dispenser for salt Filters Cutlery basket Bottom basket Dispenser for rinse aid Detergent dispenser Lock for detergent dispenser Rating plate * depending on model en Selecting language The language in the display window 12 can be set from to . “Deutsch” is the factory setting. Language Setting Deutsch L:01 English L:02 Francais L:03 Nederlands L:04 Italiano L:05 . L:06 Espanol L:07 Portugues L:08 Svenska L:09 Norsk L:10 Suomi L:11 Dansk L:12 . L:13 . L:14 . L:15 . L:16 . L:17 . L:18 . L:19 To change the language: Open the door. Switch on ON/OFF switch 1 . Hold down programme button A and press START button 10 until the digital display 3 is indicated. Release both buttons. Press programme button A until the factory set value is indicated on the digital display 3 . “Deutsch” is indicated in the display window 12 . Press programme button C . Each time the button is pressed, the set value increases by 1; after , the setting goes back to . Press START button 10 . The set value is saved. Close the door. en Water softening system To ensure good washing results, the dishwasher requires soft water, i.e. containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container. Tap water above 7 dH (from set value ) must be softened. The water is softened with salt (regeneration salt) in the water softening system of the dishwasher. The setting and therefore the required amount of salt depends on the degree of hardness of your tap water (see table). Set The amount of salt dispensed can be set from to . Sal is not required at the set value . Find out about the hardness value of your tap water. Your water supply company will assist you. Set value can be found in the water hardness table. Open the door. Switch on ON/OFF switch 1 . Hold down programme button A and press START button 10 until on the digital display is indicated . Release both buttons. The LED for button A flashes and the digital display displays the factory setting . To change the setting, press programme button C . Each time the button is pressed, the set value increases by one level; when the value of has been reached, the display jumps back to (off). Press START button 10 . The chosen setting has now been stored. Close the door. Water hardness table en Salt Using salt Always refill with salt immediately before switching on the appliance. This ensures that overrun salt solution is immediately washed out and does not corrode the rinsing tank. Open the screw-type cap of the compartment 28 . Fill the tank with water (only required when switching on the appliance for the first time). Then add dishwasher salt (not table salt or tablets). The water is displaced and runs out. As soon as the salt refill indicator on the fascia is lit, top up the salt. 5 Switching off salt refill indicator/water softening system If the salt refill indicator 5 is impaired (e.g. when using combined detergents containing salt compone...

Download now

Please, enter two numbers from picture: