Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Warnings Never fill the salt dispenser with detergent. You will destroy the water softening system. To prevent corrosion, always refill with salt immediately before switching on the appliance. * depending on model Using detergents with salt component If combined detergents with a salt component are used, salt can usually be omitted up to a water hardness of 21 dH (37 fH, 26 Clarke, 3.7 mmol/l). If the water hardness is over 21 dH, salt must be used. en Rinse aid As soon as the rinse-aid refill indicator 10 lights up on the control panel, refill with rinse aid. The rinse aid is required for stain-free utensils and clear glasses. Use only rinse aid for domestic dishwashers. Combined detergents with rinse-aid component may be used up to a water hardness of 21 dH (37 fH, 26 Clarke, 3,7 mmol/l) only. If the water hardness is over 21 dH, rinse-aid must be used. Open the dispenser 29 by pressing and lifting the plate on the cover. Carefully pour rinse aid up to the max. mark in the filler opening. Close cover until it clicks shut. To prevent excessive foam formation during the next rinse cycle, remove any rinse aid which has run over with a cloth. Setting amount of rinse-aid The amount of rinse aid dispensed can be set in 4 stages. Accordingly 0, 1, 2 or 3 displays are lit. (see water hardness table). Factory setting: 2. Do not change the amount of rinse-aid unless streaks (select lower setting) or water stains (select higher setting) are left on the utensils. Open the door. Switch on ON/OFF switch 1 . Hold down button > 6 and press Start button 9 until the End display 8 and salt refill indicator 11 flash. Release buttons. Keep pressing button > 6 10 until the rinse aid refill indicator flashes. Release buttons. The rinse-aid refill indicator 10B flashes and the displays A and are lit (= setting 2). Change the setting as follows: Press button < 5 until the required setting has been selected. Press Start button 9 8 . The End display and rinse aid refill indicator 10 go out. The selected setting is saved. Close the door. Switching off rinse-aid refill indicator If the rinse-aid refill indicator 10 is impaired (e.g. when using combined detergents containing rinse-aid component), it can be switched off. Proceed as described under “Setting amount of rinse aid” and select setting 0. The rinse-aid refill indicator 10 is now switched off. en Utensils Not suitable Cutlery and utensils made of wood. Delicate decorative glasses, craft and antique utensils. These decors are not dishwasher-proof. Plastic parts not resistant to heat. Copper and tin utensils. Utensils which are soiled with ash, wax, lubricating grease or ink. Aluminium and silver parts have a tendency to discolour and fade during the wash cycle. Even some types of glass (e.g. crystal glass objects) may turn cloudy after many wash cycles. Glass and utensil damage Causes: Glass type and glass production process. Chemical composition of the detergent. Water temperature of the wash programme. Recommendation: Use only glasses and porcelain which the manufacturer designates as dishwasher-proof. Use a detergent which protects utensils. Take glass and cutlery out of the dishwasher as soon as possible after the programme ends. Loading the dishwasher Remove large food remnants. It is not necessary to prerinse utensils under running water. Place the utensils so that . they are secure and cannot tip over. . all utensils with their openings face down. . parts with curves or indentations are at an angle, thereby allowing water to drain. . does not obstruct rotation of the two spray arms 23 and 24 . Very small utensils should not be washed in the machine, as they may fall out of the baskets. Unloading the dishwasher To prevent water from dripping off the upper basket onto the utensils in the lower basket, it is recommended to empty the appliance from the bottom up. Cups and glasses Top basket 20 * depending on model en Pans Bottom basket 28 Cutlery basket You should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointedimplements and knives on the knife shelf. Folding spikes * * depending on model The spikes can be folded down to improve arrangement of pans, bowls and glasses. Knife shelf * * depending on model Long knives and other utensils can be arranged horizontally. You can remove the knife shelf to wash taller utensils. Re-insert the knife shelf in the correct position. en Small accessories holder * * depending on model Light-weight plastic accessories, e.g. cups, lids, etc. can be held securely in the small accessories holder. Adjusting the height of the basket * * depending on model If required, the height of the upper utensils basket can be adjusted to provide more space for tall utensils either in the upper or lower basket. Appliance height 81.5 cm Appliance height 86.5 cm Top basket Bottom basket Setting 1 max. j 24 cm 33 cm Setting 2 max. j 26.5 cm 30.5 cm Setting 3 max. j 29 cm 28 cm Select one of the two following proced...
Other models in this manual:Dishwashers - SMV53E00TC/17 (2.48 mb)
Dishwashers - SMV53E00TC/22 (2.48 mb)
Dishwashers - SMV53E00TC/25 (2.48 mb)
Dishwashers - SMV53E00TC/28 (2.48 mb)