Votes - 0, Average rating: 0 ( )

Manafacture: Bosch File size: 7.91 mb File name: Language of manual:

Your Dishwasher installation Manual has information on the recommended temperature for your household hot water supply. NOTE: to accelerate and enhance drying, open the dishwasher door, pull the top rack a few inches out of the dishwasher, and prop the dishwasher door against the top rack. OPTIDrY™ this feature senses when the unit is low on rinse agent and automatically increases the drying time. Additional Drying Heat With this option you can raise the temperature of the rinse water and increase the drying time, which will result in improved drying. press and hold the left “Cancel Drain” button, then press and hold the On/Off button. When the LED display shows a “0” or a “1”, release both buttons. to enable the Additional Drying Heat, press the left “Cancel Drain” button until the LED display shows a “1”. to disable the Additional Drying Heat, press the left “Cancel Drain” button until the LED display shows a “0”. press the On/Off button to save the setting. Unloading the Dishwasher Unload the bottom rack irst. unload the silverware basket(s). they are easily removed for unloading. unload the top rack. if the Extra tall item Sprinkler was installed, return the dishwasher to its normal condition (see the Loading Extra tall items instructions in the “Loading the Dishwasher” section of this manual). “Sanitized” Light When the “Sanitized” light “ ” appears, it means that the dishware and kitchenware that was just washed has been sanitized according to the requirements of the national Sanitation foundation (nSf). for more information on nSf certiication, go to the Wash Cycle Information section of this manual. The Cycle Completion Signal this Cycle Completion Signal is a tone that sounds when your dishwasher inishes washing and drying your dishes. You can either disable the tone, or you can set it at one of two volumes (your dishwasher leaves our factory with the tone set on the lower volume). to change the Cycle Completion Signal Volume: . Open the dishwasher door far enough to expose the control buttons. 2. press and hold the right “Cancel Drain” button then press and hold the On/Off button. . When the light on the “Cancel Drain” button you are pressing illuminates and the tone begins to sound, release both buttons. . press the right-most “Cancel Drain” button until the tone is either at the desired volume or is silent. 5. press the On/Off Button. 6. Shut the dishwasher door. the Cycle Completion Signal is now set, and you may wash your dishes as usual. Check/Clean the Stainless Steel Inner Door and Tub Clean the outer edges of the inside door panel regularly to remove debris that might collect there from normal loading. if spots begin to appear on the stainless steel tub or inner door, make sure the rinse agent reservoir is full. Check/Clean the Spray Arm Nozzles Occasionally check the spray arms to ensure that the spray arm nozzles (holes) are unobstructed. You must remove the spray arms to check them for obstruction. To remove the top spray ar...

Download now

Please, enter two numbers from picture: