Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Arrange utensils in a sloping position. Use rinse aid. If required, increase softening setting. Washable or water-soluble coat-Detergent substances are deposited. Change detergent brand. ings in the container or on These coatings cannot usually be the door. removed with chemicals (appliance Clean appliance mechanically. cleaner, ...). If there is a “white coating” on Increase softening setting and change deter- the container floor, the water softening gent if required. system has been set marginally. Salt dispenser cover 1b not closed. Close salt dispenser cover correctly. Only for glasses: Initial glass corrosion See Glass and utensil damage. – can only apparently be wiped off. White, stubborn coatings; limes-Detergent substances are deposited. Change detergent brand. cale on the utensils, container or These coatings cannot usually be door. removed with chemicals (appliance Clean appliance mechanically. cleaner, ...). Hardness range incorrectly set or water Set water softening system according hardness greater than 8.9 mmol/l. to instructions for use or top up salt. 3 in 1 detergent or bio/eco detergent Set water softening system according not effective enough. to instructions for use or use separate detergents (proprietary detergent, salt, rinse aid). Underdosing of detergent. Increase detergent dosage or change detergent. Too weak rinse programme selected. Select a more intensive rinse programme. Tea or lipstick residue on Too low rinsing temperature. Select programme with higher washing tem- the utensils. perature. Too little or unsuitable detergent. Use suitable detergent at correct dosage. Utensils precleaned too intensely; sen-Do not prerinse utensils. Remove only large sors therefore decide on weak pro-food remnants. gramme sequence. Stubborn soiling cannot be completely removed. Recommended programme Eco 50° Coloured (blue, yellow, brown), Film formation consisting Can be partly removed with machine cleaner difficult to remove to non-removaof ingredients from vegetables (e.g. or by mechanical cleaning. Coatings are harmble coatings in the appliance or cabbage, celery, potatoes, noodles, ...) less. on stainless steel utensils. or the tap water (e.g. manganese). Film formation caused by metallic com-Can be partly removed with machine cleaner ponents on silver or aluminium utensils. or by mechanical cleaning. 2 6 Fa ul t, w h at to do ? Fault Cause Remedial action Coloured (yellow, orange, brown), easily removable deposits inside the appliance (mainly in the floor area) Film formation consisting of ingredients from food remnants and substances from the tap water (limescale), “soapy” Check function of the water softening system (refill with salt) or, if using combined detergents (tablets), activate water softening system (see chapter Water softening system/Special salt) Plastic parts discoloured. Too low rinsing temperature. Utensils precleaned too intensely; sensors therefore decide on weak programme sequence. Stubborn soiling cannot be completely removed. Select programme with higher washing temperature. Do not prerinse utensils. Remove only large food remnants. Recommended programme Eco 50° Removable streaks on glasses, glasses with metallic appearance and cutlery. Too much rinse aid. No rinse aid added or setting too low. Set rinse aid amount to lower setting. Add rinse aid and check dosage (recommended setting 4-5). Detergent residue in the final rinse pro-Detergent dispenser cover must not be gramme section. Detergent dispenser obstructed by utensils. cover blocked by utensils (cover does Do not place utensils or fragrance dispenser not open fully). in the tablet collecting tray. Utensils precleaned too intensely; sen-Do not prerinse utensils. Remove only large sors therefore decide on weak pro-food remnants. gramme sequence. Stubborn soiling Recommended programme Eco 50° cannot be completely removed. Initial or existing, irreversible Glasses not dishwasher-proof, only clouding of glass. suitable for dishwasher. Use dishwasher-proof glasses. Avoid long steam phase (standing time after wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower). Use detergent with glass pro...
Other models in this manual:Dishwashers - DI461112/43 (2.12 mb)
Dishwashers - DI461112/44 (2.12 mb)
Dishwashers - DI461112/51 (2.12 mb)
Dishwashers - DI461112/52 (2.12 mb)