Votes - , Average rating:
(
)
)
Manafacture: Bosch
File size: 1.37 mb
File name:
Language of manual:
The document is loading, please wait
 |
The document is loading, please wait
manual abstract
Control panel ( Main switch 0 Door opener 8 Additional options ** @ Programme end display H Display “Check water supply” P Salt refill indicator X Rinse aid refill indicator ` Programme buttons ** * depending on model ** Number depending on model Appliance interior 1" Top basket 1* Knife shelf * 12 Top spray arm 1: Bottom spray arm 1B Dispenser for special salt 1J Filters 1R Cutlery basket 1Z Bottom basket 1b Lock for detergent dispenser 1j Dispenser for rinse aid 9" Detergent dispenser 9* Rating plate * depending on model en Water softening system To ensure good washing results, the dishwasher requires soft water, i.e. containing low amounts of lime, otherwise white limescale will be deposited on the utensils and inner container. Tap water above 9° Clarke must be softened. The water is softened with salt (regeneration salt) in the water softening system of the dishwasher. The setting and therefore the required amount of salt depends on the degree of hardness of your tap water (see table). Setting The amount of salt dispensed can be set in 4 stages depending on the hardness of your water. Accordingly 0, 1, 2 or 3 displays are lit (see table). – Find out about the hardness value of your tap water. Your water utility company will help you with this. – Setting can be found in the water hardness table. Water hardness table – Open the door. – Hold down the programme button + and switch on the main switch (, then release both buttons. The display P flashes and the buttons # and + light up. (Hardness value has been set to 2 at the factory.) To change the setting: – Press programme button +. Each time the button is pressed, the value increases by one setting. You can select a set value between 0 and 3 according to the hardness of your water. When the buttons #, + and 3 light up, the maximum hardness value has been reached. When the button is pressed again, the lamps go out and the set hardness value is set to 0. – Switch off the main switch (. The chosen setting has now been stored. – Close the door. . " . . . #. . . ! !! en Special salt $ Using special salt Always refill with special salt immediately before switching on the appliance. This ensures that overrun special salt solution is immediately washed out and does not corrode the rinsing tank. – Open the screw-type cap of the compartment 1B. – Fill the tank with water (only required when switching on the appliance for the first time). – Then add salt (not table salt). The water is displaced and runs out. * depending on model The salt refill indicator P on the fascia is lit. It goes out as soon as a sufficiently high salt solution has formed. If the set hardness value is “0”, do not add salt because no salt is used during operation; the salt refill indicator is switched off. If the set values 1 to 3 are displayed, salt must be added. Using detergents with salt component If combined detergents with a salt component are used, salt can usually be omitted up to a water hardness of 21°...
Other models in this manual:Dishwashers - CP532V9/31 (1.37 mb)
Dishwashers - CP532V9/32 (1.37 mb)
Dishwashers - CP532V9/35 (1.37 mb)
Dishwashers - CP532V9/36 (1.37 mb)