|
manual abstract
DISHWASHERINSTALLATION AND FITTING 1 UNPACKING THE DISHWASHER UNPACKAGING DISHWASHERINSTALLATION AND FITTING 1 UNPACKING THE DISHWASHER UNPACKAGING 2 PLUMBING IN 2 PLUMBING IN El lavavajillas esta The dishwasher is equipped with a high pressure water connection pipe with a 3/4 (1.905 cm) directional internal pipe thread at normal temperature and pressure values (NPT). In order to make its installation easier, the dishwasher includes a 3/8” (0.9525 cm) brass compression part for 3/4 NPT which adapts the pipe connector to a 3/8” compression part which incorporates the majority of the valves which close the water connection for domestic dishwashers. Alternatively, the pipe can be coupled directly to a male 3/4 brass NPT connector which is available in most hardware stores. Adjust the direction of the pipe and the connection which comes out of the rear part of the appliance following the installation instructions. 3/8” Comp x 3/4” BSP Closing valve Washer Water connection pipe Closing valve 3/4" NPT Water connection pipe b1 b2 WARNING DRAINAGE Connect the drainage pipe incorporated into a waste disposal unit, on a drainage pipe tap or in a residual gap depending on plumbing standards in force. It is possible to lengthen the drain pipe with material resistant to hot water and detergent. Always keep an inner diameter of at least 5/8” (1.5875 cm). Never exceed the maximum distance of 9” (22.86 cm) to the drainage piping. Raise the drain pipe and fasten it to the lower part of the worktop. Lower it again to the drainage connection point following these instructions: 1. The connection with the drain pipe must be at least 10” (25,4 cm) from the floor. 2. The connection with the drain pipe must be no higher than 35” (88.9 cm) from the floor. In order to make installation easier, the dishwasher includes an assembly bracket for curved drain pipes. With an air gap Sink Min. 10" Sink Garbage disposal unit Min. 10" Without an air gap Sink Min. 10" Sink Garbage disposal unit Min. 10" Diswasher Max. 35" Diswasher Max. 35" Diswasher Max. 35" Diswasher Max. 35" It is important that the bend of the drainage hose is properly anchored in the outlet to avoid falling out and the consequent risk of flooding. The (minimum and maximum) water operating pressure must fall between 0.05 and 0.1 Mpa. Make sure that the connector for the appliance’s lower pipe is properly adjusted before installing. IMPOR TANT 3 ELECTRICAL CONNECTION 3 ELECTRICAL CONNECTION Inside the door, on the top edge, you will find the specifications label. This label should never be removed, as it gives information about the exact model of the dishwasher, power supply, series number and warranty. IMPOR TANT It is very important that the dishwasher is connected to earth. The electrical installation, plug, socket, fuses or circuit breaker and meter must be capable of managing the maximum power indicated on the specifications label. If the power cable is damaged, it can only be substituted by the manufacturer...
Other models in this manual:Dishwashers - LFA-073 SS (958.16 kb)
Dishwashers - LFA-073 IT (958.16 kb)
Dishwashers - LFA-65 ITX (958.16 kb)
Dishwashers - LFA-65 SS (958.16 kb)