Votes - 4, Average rating: 4 ( )

Manafacture: Hobart File size: 552.48 kb File name: Language of manual:

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT. Vent Fan Control The vent fan control feature is standard on machines with gas heat; it is a field installable accessory on machines with electric heat. The maximum switching rating for a vent fan control relay connected to terminals VFC1 and FVC2 is 1.5 Amps. The vent fan control relay provides switch contacts only and does not provide the power supply for the vent fan motor. When the dishwasher is connected to the vent fan, the vent fan relay is switched on when the dishwasher is on, and off when the dishwasher is off. Hobart Infrared Booster Gas Water Heater The maximum rating for connecting a Hobart Model IB57 Dishwasher Activated infrared gas booster water heater to BSTR1 and BSTR2 is 0.5 Amp at 24 Volts. If a Stand Alone Booster Heater is used, no electrical connection to the dishwasher is allowed. Refer to the Infrared Booster Gas Water Heater Manual for additional installation details. – 12 – PL-41512-1 PL-41512-1 DETERGENT, RINSE AID, OR SANITIZER DISPENSERS — Tubing Installation All detergent, rinse aid, and / or sanitizer dispensers must have all connections sealed against leakage. REMOVE PLUGS TO INSTALL – The dishwasher uses 1.42 gallons per rack at a flow rate of 5.67 gallons per minute at 20 psig flowing pressure DETERGENT FEEDER TUBE (equivalent to a maximum head pressure of 46 feet of water). This information is used when setting the detergent, rinse aid, or sanitizer pumps. Detergent Dispenser DETERGENT SENSOR The left side of the dishwasher has two 7/8" diameter plugged holes, one upper hole and one lower hole (Fig. 7). An alternate 7/8" diameter plugged lower hole, is located on the front tank wall (Fig. 7). With the tank empty, remove one upper plug and one lower plug to ALTERNATE install the detergent dispenser. DETERGENT SENSOR • The upper hole is for installation of the detergent feeder tube. • One of the lower holes is used for installation of the detergent sensor. Rinse Aid Dispenser The rinse line flange connector on top of the dishwasher has two 1/8" NPT pipe plugs (Fig. 8). REAR PIPE PLUG • Remove either front or rear plug (Fig. 8) for installation of the rinse aid dispenser tube unless a chemical sanitizer is to be installed. If installing a chemical sanitizer, use the rear hole for the rinse aid dispenser. Chemical Sanitizer Dispenser FRONT PIPE PLUG When the dishwasher is to be operated in the chemical sanitizing mode, the machine must be converted to low-temperature sanitization by an authorized Hobart-trained service technician and a chemical sanitizer dispenser that has been tested and recognized by NSF international must be installed. • Remove the front pipe plug (Fig. 8) for installation of...

Download now

Please, enter two numbers from picture: