Votes - 2, Average rating: 5 ( )

Manafacture: Indesit File size: 3.61 mb File name: Language of manual:

Other manuals for this model:

Kitchen-ranges - UA (1.31 mb)

3. Replace all the components by following the above instructions in reverse. Adjusting the hob burners. minimum setting: 1. Turn the tap to the minimum position. 2. Remove the knob and adjust the regulatory screw, which is positioned inside or next to the tap pin, until the flame is small but steady. ! If the appliance is connected to a liquid gas supply, the regulatory screw must be fastened as tightly as possible. 3. While the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame is not extinguished. ! The hob burners do not require primary air adjustment. TECHNICAL DATA Oven dimensions (HxWxD) 34x39x41 cm Volume 54 l Useful measurements relating to the oven compartment width 42 cm depth 44 cm height 23 cm Power supply voltage and frequency see data plate Energy Label Declared energy consumption for Natural convection Class Heating mode: Convection Energy consumption for Forced convection heating mode: Fan assisted Burners may be adapted for use with any type of gas shown on the data plate, which is located inside the flap or, after the oven compartment has been opened, on the left-hand wall inside the oven. EC Directives: 2006/95/EC dated 12/12/06 (Low Voltage) and subsequent amendments - 2004/108/EC dated 15/12/04 (Electromagnetic Compatibility) and subsequent amendments - 2009/142/EC dated 30/11/09 (Gas) and subsequent amendments - 93/68/EEC dated 22/07/93 and subsequent amendments - 2002/96/EC. 1275/2008 (Stand-by/ Off mode) GB 19 GB GB Table of burner and nozzle specifications !! " # !! " !! " $%% " & # $ ' ( ) *( +* +) +* +*, )' +*, - " .% - (/ 0 ) ' ( '* ', ) * * * 12 - 1 / ) ' /+ (' ( (, 0/ * 0/ - 3 . 3 . 2 3 +*' + '/ '( +/ )/ + ( +/ ' ,4/ * S S RA K3G52S/R * At 15°C and 1013 mbar- dry gas K3 G55S/ UA ** Propane P.C.S. = 50,37 MJ/Kg *** Butane P.C.S. = 49,47 MJ/Kg Natural P.C.S. = 37,78 MJ/m3 20 Descriptionof the appliance Overall view Gas burner Containment surface for spills Hob grid GUIDE RAILS Control panel for the sliding racks position 5 GRILL position 4 position 3 DRIPPING PAN position 2 position 1 Adjustable foot Adjustable foot GB Control panel Cooktop Electronic Ignition* Thermostat light Timer Thermostat Selector Hob Gas Burners Knobs Knob knob knob JHob Gas Burners Knobs Thermostat light Thermostat knob Selector knob Electronic timer* * Only available in certain models. 21 Start-up and use GB Using the hob Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. 2. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting E. 3. Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. This may be the minimum setting C, the maximum setting E or any position in between the two. X C If the appliance is fitted with an electronic lighting device* (X), press the ignition button, marked with the symbol , then hold the BURNER knob down and turn it in an anticlockwise direction, towards the maximum flame setting, until the burner is lit. Several models are equipped with an ignition device which is built into the knob; in this case the electronic ignition device* is present (C) but the ignition button is not. Simply press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting, until the burner is lit. The burner may be extinguished when the knob is released. If this occurs, repeat the operation, holding the knob down for a longer period of time. ! If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight it. If the appliance is equipped with a flame failure safety device*(X), press and hold the BURNER knob for approximately 2-3 seconds to keep the flame alight and to activate the device. To switch the burner off, turn the knob until it reaches the stop position .. WARNING! The glass lid can WARNING! The glass lid canWARNING! The glass lid canWARNING! The glass lid canWARNING! The glass lid canWARNING! The glass lid can break in if it is heated up. Turn break in if it is heated up. Turnbreak in if it is heated up. Turnbreak in if it is heated up. Turnbreak in if it is heated up. Turnbreak in if it is heated up. Turn off all the burners and the off all the burners and theoff all the burners and theoff all the burners and theoff all the burners and theoff all the burners and the electric plates before closing electric plates before closingelectric plates before closingelectric plates before closingelectric plates before closingelectric plates before closing the lid. *Applies to the models the lid. *Applies to the modelsthe lid. *Applies to the modelsthe lid. *Applies to the mod...

Download now

Please, enter two numbers from picture: