Votes - , Average rating:
(
)
)
Manafacture: Hyundai
File size: 428.2 kb
File name: INST95-7333.pdf
Language of manual:
The document is loading, please wait
 |
The document is loading, please wait
manual abstract
4 *Note: Refer also to the instructions included with the aftermarket radio. 95-7333 DASH DISASSEMBLY HYUNDAI SONATA 2009-10 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Remove shifter knob from stem. (Figure A) 3 Unclip and remove the shifter trim panel. (Figure B) 4 Unclip and remove the (2) side trim panels from the center console area. (Figure C) Continued on page 2. C 1 A B 95-7333 DASH DISASSEMBLY HYUNDAI SONATA 2009-10 5 Remove (2) Phillips screws then unclip and remove the small trim panel below the factory climate controls and above the pocket. (Figure D,E) 6 Unclip and remove the trim panel surrounding the radio and including the climate controls and vents. (Figure F) 7 Remove (4) Phillips screws securing the radio. Unplug and remove the radio. (Figure G) Continue to kit assembly. Qp d>| У V D E G F 2 95-7333 KIT ASSEMBLY DOUBLE DIN/STACKED ISO MOUNT UNITS PROVISION *Note: Refer also to the instructions included with the aftermarket radio. A 1 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 2 Slide the Double DIN or stacked ISO mount unit(s) into the bracket/trim plate assembly and secure the unit(s) to the assembly using the screws supplied with the unit(s). (Figure B) Continue to final assembly. B 3 95-7333 FINAL ASSEMBLY FINAL ASSEMBLY (A) Strip wire ends back 1/2" B) Twist ends together C) Solder D) Tape 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble radio and dash assemblies in reverse order of disassembly. FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually tape off ends of any unused wires to prevent electrical short circuit. METRA / EIA WIRING CODE 12V Ignition / Acc...... . . . . Red Right Front (+)..... .......Gray 12V Batt / Memory..... .... Yellow Right Front (-)...... .......Gray/ Black Ground.............. . . . . Black* Left Front (+)...... .......White Power Antenna........ .... Blue Left Front (-)....... .......White / Black Amp Turn-On ......... . . . . Blue / White Right Rear (+) ..... .......Violet Amp Ground.......... . . . . Black / White Right Rear (-)...... .......Violet / Black Illumination .......... .. . . Orange Left Rear (+) ...... .......Green Dimmer ............. .... Orange / White Left Rear (-)....... .......Green / Black *NOTE: When a Black wire is not present, ground radio to vehicle chassis. All colors may not be present on all leads due to manufacturer's specifications. 4 () B C CJ-. ) D v- ■MM -J 95-7333 NOTES 5 95-7333 INSTRUCTIONS 1-800-221-0932 y REV. 04/30/10 ©COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST95-7333...