Votes - 3, Average rating: 3.3
(
)
)
|
Other manuals for this model:
manual abstract
Press the .–/+> button to show the following information. 1: product name 2: built-in flash memory capacity 3: serial number 4: software version To cancel the Menu mode Select [RETURN] in the menu screen or press the MENU button. Other functions 33 B Other Information Precautions On installation • Never use your Network Walkman where it will be subjected to extremes of light, temperature, moisture or vibration. • Never leave the Network Walkman exposed to high temperature, such as in a car parked in the sun or under direct sunlight. On the headphones Road Safety Do not use headphones while driving, cycling, or operating any motorized vehicle. It may create a traffic hazard and is illegal in many areas. It can also be potentially dangerous to play your Network Walkman at a high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. Preventing hearing damage Avoid using the headphones at a high volume. Hearing experts advise against continuous, loud and extended play. If you experience a ringing in your ears, reduce the volume or discontinue use. Caring for others Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to the people around you. Warning If there is lightning when you are using your Network Walkman, take off the headphones immediately. On the use • When using a strap, careful to avoid hooking it on objects you pass by. • Do not use the Network Walkman on an aircraft. On cleaning • Clean your Network Walkman casing with a soft cloth slightly moistened with water or a mild detergent solution. • Clean the headphone plug periodically. Note Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzene as it may mar the finish of the casing. If you have any questions or problems concerning your Network Walkman, please consult your nearest Sony dealer. Troubleshooting If you experience any of the following difficulties while using your Network Walkman, use this troubleshooting guide to help you to remedy the problem prior to consult a Sony dealer. Should any problem persist, consult your nearest Sony dealer. If a problem occurs while connected to your computer, also refer to “Troubleshooting” in the online help of the supplied software. To reset the player If your Network Walkman does not operate normally, or if there is no sound, even after checking the troubleshooting guide below, remove the battery and re-insert it. What happened? On operating Symptom Cause/Remedy There is no sound. Noise is generated. • The volume level is set to zero. c Turn the volume up (page 14). • The headphone jack is not connected properly. c Connect the headphone jack properly (page 14). • The headphone plug is dirty. c Clean the headphone plug with a soft dry cloth. • No audio files are stored in the memory. c If “NO DATA” is displayed, transfer audio file(s) from the computer. Other Information Buttons do not work. • The GROUP/HOLD switch is set to HOLD. c Set the GROUP/HOLD switch to (NORMAL) (page 25). • Your Network Walkman contains moisture condensation. c Leave your Network Walkman aside for a few hours. • The remaining battery power is insufficient. c Replace the battery (page 9). The volume is not loud The AVLS is enabled. enough. c Disable the AVLS (page 27). There is no sound from the The headphone jack is not fully inserted. right channel of the c Connect the headphone jack fully (page 14). headphones. Playback has stopped The remaining battery power is insufficient. suddenly. c Replace the battery (page 9). continued 35 Troubleshooting On the display window Symptom Cause/Remedy The backlight is not turned LIGHT is set to “OFF.” on. c In the menu mode, set “LIGHT” to “ON” (page 31). “s” is displayed for a title. Characters that cannot be displayed on your Network Walkman are involved. c Use the supplied SonicStage software to rename the title with appropriate characters. On the connection with the computer or supplied software Symptom The software cannot be installed. “USB CONNECT” is not displayed when connecting to the computer with the dedicated USB cable. Cause/Remedy An operating system not compatible with the software is used. c For details, refer to the SonicStage operating instructions. • Please wait for authentication of the SonicStage software. • Another application is running on the computer. c Wait for a while and reconnect the USB cable. If the problem persists, disconnect the USB cable, restart the computer, and then reconnect the USB cable. • The dedicated USB cable has disconnected. c Connect the dedicated USB cable. •A USB hub is used. c Connecting via a USB hub is not guaranteed. Connect the dedicated USB cable directly to the computer. Your Network Walkman is not recognized by the computer when it is connected to the computer. Song cannot be transferred to your Network Walkman. The dedicate USB cable is disconnected. c Connec...
Other models in this manual:Portable Players - NW-E103 (433.5 kb)
Portable Players - NW-E107 (433.5 kb)