Votes - 2, Average rating: 4
(
)
)
|
manual abstract
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquid such as vases, shall be placed on the apparatus. IMPORTANT SAFETY INSTRUCTIONS THE IMPORTANT SAFETY INSTRUCTIONS SHALL INCLUDE, AS APPLICABLE TO THE APPLIANCE, STATEMENTS THAT CONVEY TO THE USER THE INFORMATION ITEMIZED IN THIS PARAGRAPH: 1. Read these instructions -All the safety and operating instructions should be read before the appliance is operated 2. Keep these instructions -The safety and operating instructions should be kept for future reference. 3. Heed all warnings -All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow all instructions -All operation and use instructions should be followed. 5. Do notusethis apparatusnearwater-The appliance should not be used near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like. 6. Clean only with dry cloth -The appliance should be cleaned only as recommended by the manufacturer. 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. -The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. 8. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11. Only use attachments / accessories specified by the manufacturer. 12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combinationtoavoid injury from tip-over. 13. Unplug this apparatus during lightning storms or when unused for a long periods of time. 2 IMPORTANT SAFETY INSTRUCTIONS 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 15. Wall and Ceiling Mounting -The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer. 16. Power Lines -An outdoor antenna should be located away from power lines. 17. Outdoor Antenna Grounding -If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electrical Code, ANSI/ NFPA No.70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure 1. ANTENNA LEAD IN WIRE ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) FIGURE 1 EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE GROUND CLAMP ELECTRONIC SERVICE EQUIPMENT GROUND CLAMP GROUNDING CONDUCTORS (NEC SECTION 810-21) POWER SERVICE GROUNDING S2898A NEC-NATIONAL ELECTRIC CODE ELECTRODE SYSTEM (NEC ART 250.PART H) 18. Object and Liquid Entry -Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. 19. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Do not overload wall outlet. 20. Servicing -The user should not attempt to se rvice the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel. 21. All markings are located on the exterior bottom enclosure of the apparatus. 22. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 23. The mains plug is used as the disconnect device from the mains. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT. FULLY INSERT THE PLUG TO MAIN POWER S...