Votes - 3, Average rating: 4.7
(
)
)
|
manual abstract
In the event of the fuse requiring replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux retailer and must be of the same colour as indicated by the coloured insert on the base of the plug. If difficulty is experienced in obtaining a replacement, contact an Electrolux Service Agent or phone 08706 055055. In no circumstances must the plug be used without a correct fuse cover fitted. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home. The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cleaner is double insulated and no earth connection is necessary. It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee. 13 Amp Fuse Fuse cover Fuse Blue Brown Cord Clamp SERVICE Should you require service on your Electrolux cleaner, please telephone 08706 055055 if you reside in the UK, otherwise contact your nearest Service Agent. Important - in the event of the mains supply cable of this steam cleaner requiring replacement, we recommend that this be carried out by a Electrolux Service Agent. Spares New cloths can be obtained from Authorised Electrolux Dealers and electrical retailers. If difficulty is experienced in obtaining spares please call us on 08706 055055 if you reside in the UK, otherwise contact your nearest Service Agent. Rating Plate The model and type are indicated on the rating plate located on the back side of the MODEL TYPE cleaner. For prompt and complete service information, always refer to these numbers when inquiring about service. VOLTS WATTS HERTZ ELECTROLUX Model & Type No. ________________ Main Features of the Multi-Steamer Steam Cleaner Thank you for having chosen our product and allow us to congratulate you for having purchased the Electrolux Multi- Steamer steam cleaner. The Electrolux Multi-Steamer steam cleaner achieves a high degree of hygienic and degreasing power on many surfaces. It turns water into steam in just a few minutes, so when contact is made with surfaces dirt and grime is removed. Since the Electrolux Multi-Steamer steam cleaner uses the active power of steam without the use of detergents or soap, it is safe for the environment. Some surfaces that can be cleaned with the Multi-Steamer steam cleaner are: sealed hard floor surfaces, upholstery, sealed grout, bathroom and kitchen tile, stove tops, removable exhaust filter over stoves, windows and mirrors. The fabric tool may be used to steam wrinkles out of clothing, window coverings, etc. CAUTION: Do not direct steam at the body. Other Advantages of the Electrolux Multi-Steamer Steam Cleaner The Electrolux Multi-Steamer steam cleaner can kill dust mites and some types of bacteria, such as salmonella and E-coli when used properly. To disinfect a specific area, position the steam cleaner over the area, not more than 2,5 cm away and slowly move across the surface. This allows the surface under the steam cleaner to reach approximately 77 °C . Use this procedure to disinfect surfaces in: the bathroom, food preparation areas, pillows and bedding, pet sleeping quarters, etc. Description of the Multi-Steamer Steam Cleaner 1. Handle 2. Safety filler cap 3. Steam ready amber indicator light 4. Power on green indicator light 5. On (I) Off (O) Switch 6. Cleaner body 7. Floor cloth 8. Floor brush 9. Elbow 10. Accessory connector for use with wand 11. Extension wands 12. Round brush (1 brass, 1 plastic) 13. Angle nozzle 14. Cloth for fabric brush 15. Window squeegee 16. Fabric brush 17. Straight nozzle 18. Nozzle connection 19. Safety slider button 20. Steam delivery trigger 21. Spray nozzle 22. Hose 23. Measuring cup and liquid dispenser 24. Funnel 2...