Votes - 3, Average rating: 3.7
(
)
)
|
manual abstract
When the dirt is hard to remove, use a mild detergent and wipe gently. • Do not operate the appliance beyond its specified temperature, humidity or power source ratings. Use the appliance at temperatures within -10‘C - +55°C (14°F - 131T) and at a humidity below 90 %. The input power source for this appliance is 12 V DC. Note: The images on the monitor are displayed reversibly on right and left, just like that of the rearview mirror. 4 MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS • RearView • Front View 'C FOCUS Q © Ed © Mode Selector (STD BY/ON) Toggles the operation mode standby and on. STD BY: No image is on the monitor but the picture tube is preheated on standby. The indicator is iit green while this mode is selected. ON: Displays camera images on the monitor. The indicator is lit amber while this mode is selected. (D Auto Brightness Control Sensor (ABC) This sensor detects illumination intensity. (D Monitor Fixing Screws These four screws are used to secure the monitor. The monitor can be tilted approximate 30 degrees by loosing these screws. © Mounting Bracket Installs the monitor to a vehicle. (D Contrast Control (CONTRAST) Adjusts the picture contrast. Turn this control clockwise to increase the picture contrast, and turning the control counterclockwise has the reverse effect. (D Brightness Control (BRIGHT) Adjusts the picture brightness. Turn this control clockwise to increase the picture brightness, and turning the control counterclockwise has the reverse effect. © Focus Control (FOCUS) This control is preset at the factory. © Remote/Camera Connector (REMOTE/CAMERA) This 9-pin connector is used to connect the remote cable assembly supplied as an accessory for supplying the power and connecting the camera. (4) Audio Control (AUDIO) Adjusts the volume. Turn this control clockwise to increase the volume, and turning the control counterclockwise has the reverse effect. 5 INSTALLATIONS 1. Remove the Mounting Bracket from the monitor by removing the four monitor fixing screws. 2. Place the mounting bracket on the position to be installed in the vehicle, and secure it with the four bolts (procured locally 06 mm). 3. Place the monitor onto the bracket and tighten with the four monitor fixing screws. 4. Install the GP-Q48 monitor hood (option) by tightening the two screws supplied, if required. 5. Connect the remote cable to the REMOTE/CAMERA connector on the rear of the monitor. The remote cable is designated as shown in the figure below. To Rearview Monitor © +12 V DC (red) CD Remote In (blue) CD Not Used © Ground (green) CD Audio In (white) CD Video In (yellow) © Ground (green) CD Camera Ground (black)