Votes - 2, Average rating: 4.5 ( )

Manafacture: Kenmore File size: 1.2 mb File name: 6dc97d77-cb8d-40b5-986c-bbe4e1042d7a.pdf Language of manual:

Humidityisshown inwindow (8).When pressing arrowkeywhenthevalueis35%,theunitwill operate continuously. In this continuous operation, Lo will be displayed in the window (8). To leave continuousoperation, pressthe arrowup or changethe setting. 9 Cycle Timer Setting (10) In this setting, the unit will run for either 3, 6, or 12 hours, then shut offfor 3, 6, or 12 hours. Cycle time can be adjusted by pushing the timer arrow up or down (4!5) repeatedly to set operating time for 3, 6, or 12 hours. The cycle timer function will continue until you change the setting or turn the unit off. Delay Start (11) Unit can be programmed to turn on at a desired delay time by pushing the timer arrow and key (4/5). Time can be adjusted in 1 hour increments ranging from 1 to 12 hours. Delay time will be shown in window (8) and will count down to start time in 1 hour increments. FAN SPEED (3) Press Fan Speed to toggle between Auto, Low, and High fan speeds. Speed will be shown in FAN SPEED INDICATOR (6). When AUTO is selected, the unit wilt adjust the fan speed accordingly depending on the humidity level. BUCKET FULL INDICATOR (7) When the collection bucket is full, BUCKET FULL indicator (7) will come on. The dehumidifier will not run until the bucket is empty. IMPORTANT: When the unit is tumed off and restarted, the unit will operate at the previous operation setting. NOTICE: A power failure will require the unit to be turned back on manually and adjusted to the desired setting. OPTIONMANUALLY 1.EMPTYING 1. Pull out the bucket, grasping side handles. 2. Carry the bucket by grasping the inside handle of the bucket. 3. After emptying the bucket, replace the bucket in the dehumidifier. NOTE: Dehumidifier will not work when the BUCKET FULL light is on or without the bucket properly placed in the unit. OPTION 2, GRAVITY DRAIN HOSE (Hose Not Provided) 1. Take off GRAVITY DRAIN Cap. (Fig. 1) 2. Assemble the DRAIN CONNECTOR to the dehumidifier by turning clockwise. (Fig.2) 3. Next, Screw a standard drain hose to drain connector by turning clockwise. (Fig.3) Fig.1 Fig.2 Fig.3 _WARNING • Disconnect power supply cord from receptacle before performing any maintenance. Fig.l Fig.2 Fig.3 Fig.4 Fig.5 CLEANING FRONT GRILL AND AIR FILTER 1. Remove the bucket from unit. Air filter is located behind front grill. (Fig.l) 2. Pull the filter down and away from unit until it is all the way out. (Fig.2) 3. Wash with mild detergent. Rinse thoroughly. Air dry away from direct sunlight. (Fig.3) 4. FRONT GRILL can be cleaned using a vacuum cleaner or a soft brush to remove dust. (Fig.4) 5. After cleaning, assemble the air filter to front grill. (Fig.5) NOTE : Check your filter periodically to insure proper operation. 10 CLEANING THE EXTERIOR Clean the exterior using a soft brush or dry towel. But do not spray water directly on the exterior. CLEANING THE BUCKET Remove the bucket from the unit. Lift off bucket cover. (Fig.1) Clean the inside of bucket as needed. (Fig.2) After cleaning, replace the bucket cover and slide the bucket into the unit. (Fig.3) Check the float switch to make sure it is not obstructed. Proper position of the bucket and the float switch is required for the dehumidifier to turn on. Fig.2 Float Switch Fig.3 11 Beforecallingtrythesuggestionstoseewhetheryoucansolveyour forservice,below problem without outside help. PROBLEMS CHECK POINT SOLUTIONS Dehumidifier does not Is the power cord plugged into Plug the power cord securely into a work when pressing a grounded 3-prong outlet? grounded 3-prong outlet. the POWER button. ON Is BUCKET FULL light on? Does BUCKET FULL light Empty the re-install. water bucket and appear after emptying the Check the float switch to make sure water bucket? it is free and not obstructed. Dehumidifier is Is the compressor running as The unit may be in the defrost operating, but the unit well as the fan? mode. The fan is running but not the is not drawing any water compressor. The unit will return to dehumidification automatically. Loud noise and/ Is the unit on a level surface? Move the unit to a level surface. or vibration during operation. Sounds. This is the normal sound of the Sounds like flowing water during and after operation. refrigerant flowing through the coils. It makes a pinging sound...

Download now

Please, enter two numbers from picture: