Votes - 2, Average rating: 4
(
)
)
|
manual abstract
( ...............................) .MODE.......................... .).MODE...................... Ang : ....... Hgt + Hgt2 : 2.... Act : .... Hor : .... Hgt : ..( .) ..... .......... ....... POWER ... .. ....... ..20 .... ...... .. ....... .............. .........(1) ..(1..)..(.....: ......... ...............) Ang Hgt Act Hor ... ...( .) .... (............) ( .....................) ......... ........... .....OFF ..... .............. ....... ..................... ....................... ............. ...30 ...... .......... ../..... .MODE................. ................ ..........POWER ...... .............. ......... ..( .) ....... ......... 2 ....... ...... ..... .... Act : .... Hor : .... Hgt : ..( .) ..... Ang : ....... ............... ................. .........(2) 2 ...... ( .....;...............’.. ...............) ...1 ...2 ...( .) .... 2 ...... ......... ....... ...30 ...... .......... ...1 ... ...1 ...( .) ....... POWER ... .. .. ......... ........... .MODE..............2 . ................... ..........POWER ........ ..................... ................. ...2 ... POWER ... .. .. 2....... .2 ....... .......... .... . ...1....... ...2...... ( 2......) ...’.....MODE....... ...2..... 247.2 Act(1) 224.0 Hor(1) 25.0° Ang(1) 104.5 Hgt(1) 227.5Act(2) 15.0° 247.2Act(1) Ang 65.0 Hgt+Hgt2 224.0Hor(2) 10.0° Ang(2) 39.5 Hgt(2) 227.5Act(2) J J Printed in China (191K)/1DE Display linear distance. POWER button Push Keeping the button pressed allows continuous measurement of up to 20 seconds. Measurement After POWER is Display of horizontal distance. turned on. Aim at the target. Switching measurement modes with MODE button in the status of Limited/ Full mode. (See separate “Measurement and Display” sheet for switching between Full and Limited modes.) Press and release MODE button to switch measurement mode. Note: Holding down MODE button longer switches the display unit. Instruction manual for simple measurement (1) General (1-point) measurement (Measurement order: ......... , then repeat) Ang Hgt Act Hor Target point Rangefinder (eyes) Internal display (”Linear distance mode”) (Display will be different depending on the setting mode.) Result is stored until next measurement starts. Default: “Last Use” settings. First target priority setting. End of measurement is indicated with --- and no display of . Measurement values of the “Last Reading” are displayed on external LCD when terminating measurement. Power turns off 30 seconds after the last operation. Limited/Full mode When the MODE button is pressed, data in each measurement mode is displayed in sequence. When the POWER button is pressed with the selected mode, measurement and display are made in that measurement mode. Display of the target’s height from the rangefinder’s (eyes’) level. Display angle (from horizontal). Display of the vertical separation (height between two points). No data displayed. Full mode External LCD Act (Linear distance) Hor (Horizontal dist...
Other models in this manual:Optical Devices - Anleitung für einfache Messung (4.47 mb)
Optical Devices - Руководство пользователя (4.47 mb)
Optical Devices - Guía de usuario (4.47 mb)