Votes - 3, Average rating: 4.3 ( )

Manafacture: Azden File size: 340.34 kb File name: Language of manual:

Lecturers, Actors, Actresses, etc. Model 31IT: Instrument body-pack transmitter. Designed for electric guitar and bass. 32BT Lavalier Microphone with body-pack transmitter: (1) Open the battery compartment lid by sliding it in the direction indicated and raising it. (2) Insert one fresh Alkaline 9-volt battery into the compartment. Make sure battery polarity is correct. (3) Frequency Labe. The Frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receive. in use must also be on the same frequency. (4) Audio Input Level Contro. Turn clockwise to increase, or counter-clockwise to decrease the input level. A small screwdriver is supplie. to make adjustments. The level control is factory-preset in the center position. (5) 3 Position Switc. The left position: OF. The middle position: STANDB. The right position: O. In the .STANDBY. position, the audio is muted. (6) LED Indicato. Turns red when the switch is in .STANDBY. position and green in .ON. position. NOTE: Remove the battery if the transmitter will not be used for a long period of time. (7) Audio Output Connecto. This 3.5mm mono connector is where the mic is plugged in. This connector was designed to be used with . special .screw-down. connecting jack that eliminates the possibility of the jack being accidentally pulled out. A standard 3.5mm mono jack can also be used but will not afford the extra protection. (8) Metal Belt Cli. Used to attach the 32BT securely to a belt. 31XT Plug-in transmitter adaptor. Note: The 31XT is designed to turn any wired dynamic metal-body microphone that has an XLR output into . wireless microphone. Connecting the 31XT: Disconnect the microphone cable from the microphone by pushing down on the release button where th. microphone and cable connect. Connect the 31XT by lining up the pins on the microphone with the holes o. the transmitter, and insert. Push the 31XT into the microphone until it locks into place. Removing the 31XT. Push down on the release button and pull out. (1) Turn the bottom half of the case counter-clockwise until it is completely off. (2) Insert one fresh alkaline .AA. battery into the compartment. Make sure battery polarity is correct. Replace the bottom half of the case and turn clockwise until snug. DO NOT OVERTIGHTEN. (3. Frequency Label. The frequency label indicates what frequency (in MHz) the transmitter broadcasts on. The AZDEN receive. in use must also be on the same frequency. (4) Power Off/On: Switches the transmitter off or on. (5) Audio Off/On. Slide the switch to .On. for normal operation. Slide it to .Off. to mute the audio. NOTE: When turning the transmitter on, slide the Power .On. first, and then slide the Audio to .On.. Whe. turning the transmitter off, first slide the Audio to .Off.. (6) LED. Turns RED when the Power is .On. and the Audio is .Off.. Turns GREEN when the Power and Audio ar. .On.. (7) Level. Turn clockwise to increase, or counter-clockwise to decrease the input level. A small s...

Download now

Please, enter two numbers from picture: