2. Use phillips screwdriver to remove screw (F) holding air filter cover (G) on compressor housing (H). Remove air filter cover. F G H J 3. Remove air filter media (J). IMPORTANT: DO NOT operate compressor with air filter media removed. WARNING Compressed air stream from hose or tank drain can cause soft tissue damage to exposed skin and can propel objects leading to severe injury and / or property damage. • DO NOT direct air stream at self or others. • Always wear ANSI Z87.1 approved safety gla
Also Recommended for Use: • Safety glasses (ANSI Z87.1 approved safety glasses with side shields) • Air hose - 25 ft (7.5M), 3/8 inch diameter • Quick connector fitting - Use type I/M quick connect fittings that attach to 1/4 inch NPT thread • Hearing protection (ANSI S3.19-1974) in noisy environments • Respirator (NIOSH-approved) in dusty environments Verify Engine and Pump Oil Levels CAUTION! Any attempt to start the compressor before it has been properly serviced with the recommended oil may
If calling for assistance, please have the model, revision, and serial number information printed on the data tag available. PROBLEM CAUSE CORRECTION Excessive tank pressure - Safety Valve pops off. Pressure switch does not shut off motor when compressor reaches “cut-out” pressure or “cut-off” setting too high. Move ON - OFF switch to OFF position. Contact trained service technician. Air losses 1. Quick connect fitting cracked or loose. 2. Check valve seat dirty or damaged. 3. Defective pressure
This plug MUST be used with a grounded outlet. WARNING Improper grounding can result in electrical shock. • DO NOT use grounding adapters. • DO NOT modify the plug provided. If it does not fit the available outlet, a qualified electrician should install a proper outlet. • A qualified electrician MUST make repairs to the cord set or plug. 2. Make sure power outlet being used has same configuration as air compressor’s plug. DO NOT use a ground adapter. OR 3. Inspect plug and cord before each use.
CAUTION, when not used with the safety alert symbol ( ), indicates a situation that could result in equipment damage. Follow safety messages to avoid or reduce the risk of injury or death. Hazard Symbols and Meanings Fire Auto-start Explosion Compressed Air InhalationHot Surface Electrical Shock Flying Objects Air Injection 2 SAFETY RULES WARNING WARNING Failure to read and follow instructions in manual can result in death, bodily injury and / or property damage. • Before using this product, rea
Air Compressor Pump: Pump compresses air into tank. Check Valve: When unit is operating, Check Valve is open, allowing air to enter tank.At “cut-out” pressure, Check Valve closes, preventing air from flowing back into pump.Valve is not serviceable by user. Data Tag: (not shown) The data tag contains serial number, model number, and revision number information. Drain Valve: Valve is located near bottom of air tank and is used to drain condensation. Overload Protector: If motor overheats, overload
SAFETY SAFETY WARNING Engines give off carbon monoxide, an odorless, colorless, poison gas. Breathing carbon monoxide can cause nausea, fainting or death. • Start and run engine outdoors. • Do not start or run engine in enclosed area, even if doors or windows are open. WARNING Running engines produce heat. Engine parts, especially muffler, become extremely hot. Severe thermal burns can occur on contact. Combustible debris, such as leaves, grass, brush, etc. can catch fire. • Allow muffler, engin
In California, new small off-road engines must be designed, built and equipped to meet the State’s stringent anti-smog standards. Elsewhere in the United States, new non-road, spark-ignition engines certified for model year 1997 and later, must meet similar standards set forth by the U.S. EPA. B&S must warrant the emission control system on your engine for the periods of time listed below, provided there has been no abuse, ne glect or improper maintenance of your small off-road engine. Your emis
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.” Briggs & Stratton Corporation F. P. Stratton, Jr. Chairman and Chief Executive Officer WARRANTY PERIOD ENGINES WITHIN U.S.A. AND CANADA OUTSIDE U.S.A. AND CANADA CONSUMER USE* COMMERCIAL USE* CONSUMER USE* COMMERCIAL USE* All Vanguard. engines. 2 year – engine . All Diamond Plus., Industrial Plus., I/C. engines and sleeve bore Intek series. 2 year 1 year 2 year . 1 year Quantum. and
Each one carries a stock of Genuine Briggs & Stratton Parts and is equipped with special service tools. Trained mechanics assure expert repair service on all Briggs & Stratton engines. Only dealers advertising as “Authorized Briggs & Stratton” are required to meet Briggs & Stratton standards. When you purchase equipment powered by a Briggs & Stratton engine, you are assured of highly skilled, reliable service at more than 30,000 Authorized Service Dealers worldwide, including more than 3,600 Mas