Votes - , Average rating:
(
)
)
Manafacture: Manitowoc Ice
File size: 13.41 kb
File name: 8010523.pdf
Language of manual:
The document is loading, please wait
 |
The document is loading, please wait
manual abstract
CAUTION! Remove entire system charge before proceeding. a. Remove the insulation from the suction line liquid heat exchanger assembly. You will see the liquid line soldered to the suction line for approximately 15”. You must remove this soldered length. b. Remove the liquid line from the suction line. Starting at the evaporator end, use a pliers and a low flame torch to carefully separate the liquid line from the suction line. c. Reinsulate the suction line. Run the removed liquid line outside the suction line insulation. 5. Evacuate and recharge system with nameplate charge using ONLY HP81. 6. Pull L1 and L2 (N) (black and white) wire leads through rear 1/2” knockout hole of start component electrical box. Tighten 1/2” conduit nut to conduit fitting. 7. Screw start component electrical box to refrigeration platform close to compressor. 8. Wire-nut L1 (black) wire lead to wire lead #78 and L2 (white) wire lead to wire lead #77. 9. Break out bottom knockout of compressor electrical box and attach common, run, and start wire leads to compressor terminals, per new wiring diagram. 10. Peel backing off new wiring diagram and place over existing wiring diagram. Manitowoc Ice, Inc. 2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 8010523 Web Site - Rev. 05/21/99...
Other models in this manual:Water and Air Pumps - FS2 (13.41 kb)