Votes - 2, Average rating: 4.5
(
)
)
|
Photos and specs Yamaha RGX620Z |
manual abstract
Counter-clockwise for piezo Battery Compartment * Battery needed to use output jack #2 Pickup Selector Front Pickup ^ Front + Rear Rear Pickup Tone Control for magnetic pickup Output Jack #2 * Output from magnetic & piezo pickup * Output through pre-amp inside (active) NOTE 1 Output jack #1 & #2 can be used at one time. NOTE 2 When not in-use, unplug from output jack #2 to save battery. Output jack #1 dose not consume battery. Changing the string on SPERZEL “Trim-Lok” tuner (RGX820Z) The SPERZEL “Trim-Lok” tuners offer easy string change and improved tuning stability when using the tremolo bridge. 1) Loosen the knob ® on the back of the tuner. As the locking pin © in the string post goes down, remove the old string. 2) Place the new string from the bridge into the string hole © of the string post. Do not wind the string around the post. 3) Pull the new string tightly and tighten the knob © to lock the string. 4) Tune the strings to the pitch. NOTE Don't loose the knob © too much. It may drop out the tuner. Adjustment of tremolo unit ■ String Action Adjust the tremolo unit height by rotating the height adjustment bolts ©. ■ Intonation Adjustment If the pitch at the 12th fret is sharp compared to the harmonic tone: ^ Turn the intonation adjusting screw @ clockwise. If the pitch at the 12th fret is flat compared to the harmonic tone: ^ Tune the intonation adjusting screw @ counter-clockwise. ■ Arm Tension Turn the arm tension screw © clockwise to make the arm tighter. Turn the arm tension screw © counter-clockwise to make the arm looser....
Other models in this manual:Musical Instruments - RGX620Z-D6 (109.91 kb)
Musical Instruments - RGX820Z (109.91 kb)