Votes - 3, Average rating: 3.3
(
)
)
|
manual abstract
Flashes green continuously Connection in progress, please wait. Flashes green once Adjusting the volume level. Lights up green A connection is established. You are ready to start playback of iPod on another Yamaha product. Lights up green and flashes red Flashes red for 2 seconds: An unsupported iPhone or iPod is connected. Keeps flashing red: Connection failed. Flashes red (regardless of green status) The battery of the iPod or iPhone is low. 4 Adjust the angle of your iPod or iPhone so that it is aligned parallel to PDX-50TX. 5 To charge the iPod or iPhone, place it on PDX-50BC. ¦ Group selection switch Use this switch to set the group ID. To establish a wireless connection (AirWired) with another Yamaha product, set both the products to the same group. Group selection switch Match the group selection switch with the group ID to set. y • PDX-50TX supports “1” (A1), “2” (A2), and “3” (A3) on some Yamaha products that support “AirWired”. ¦ Disconnecting the iPod or iPhone To disconnect the iPod or iPhone from PDX-50TX (transmitter), pull the iPod or iPhone upward. y • Disconnection may be difficult under low temperature. In this case, do not disconnect the iPod or iPhone by force; loosen off the tab on the back of PDX-50TX to make the disconnection easier. 4 En ¦ ¦ Refer to the table below if the unit does not function properly. If the problem you are experiencing is not listed below, or if the instruction below does not help, contact the nearest authorized Yamaha dealer or service center. Problem Cause Remedy No sound. PDX-50TX and another Yamaha product are not connected since they are set to different groups. Set both PDX-50TX and another Yamaha product to the same group. The signals are obstructed because Remove the obstacle. there is an obstacle between the transmitting-side product and this unit. Move this unit to another position. If the device is IEEE802.11ncompliant, change the channel setting of the device so as not to affect the unit. There is a device (microwave oven, wireless LAN, etc.) outputting signals in 2.4 GHz frequency band nearby. Move PDX-50TX away from the device. The iPod or iPhone is not connected to PDX-50TX firmly. Connect the iPod or iPhone firmly. The firmware of the iPod or iPhone is not updated. Download the latest iTunes software to update the firmware of the iPod or iPhone. For details, refer to the owner’s manual supplied with your iPod or iPhone. The signal from PDX-50TX is blocked by your body or metallic objects, etc. Change the way of holding, orientation, or position of PDX50TX to avoid the object blocking the signal. The battery of iPod or iPhone is low. Charge the iPod or iPhone. The volume is turned down. Turn up the volume. It is in the process of a connection. Please wait for a while. The protection circuitry has been activated by excessive volume. Turn down the volume. Controlling volume on the iPod or iPhone does not work. The iPod or iPhone being used is not supported by this unit. Use an iPod or iPhone supported by this product. The iPod or iPhone is not connected to PDX-50TX firmly. Connect the iPod or iPhone firmly. 5 En ¦ ¦ Supported iPod ....iPod (5th generation), iPod classic, iPod nano, iPod touch Supported iPhone ...............................................iPhone, iPhone 3G, iPhone 3GS (as of August 2009) Power Supply................AC 100 to 240 V, 50/60 Hz Power Consumption .......................................... 4 W Power Consumption without connecting iPod/iPhone..................................... less than 1 W Transmission range .........Approx. 20 m (66 ft) (without interference) Maximum playback duration ..........Approx. 10 hours (from full charged iPod) Dimensions (W x D x H) PDX-50TX...........................45.4 x 21.6 x 81 mm (1-29/32 . 7/8 . 3-7/32 in) PDX-50BC............................. 56 . 20.5 . 74 mm (2-7/32 . 13/16 . 2-15/16 in) Weight PDX-50TX......................................29 g (1.02 oz) PDX-50BC...................................29.5 g (1.04 oz) This unit does not support iPod (4th generation or before), iPod without Dock connector, iPod photo and iPod mini. * Specifications are subject to change without notice The “ ” and “AirWired” are trademarks of Yamaha Corporation. iPod™, iPhone™ iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc. “Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. “Works with iPhone” means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. 6 En ¦ ¦ L’APPAREIL. 1 Pour utiliser l’appareil au mieux de ses possibilites, lisez attentivement ce mode d’emploi. Conservez-le soigneusement pour refe...