Votes - 4, Average rating: 4.5 ( )

Manafacture: Yamaha File size: 702.63 kb File name: Language of manual:

CAUTION • To prevent the Hi-Hat Stand from coming loose during performance, tighten all securing bolts and adjustment bolts firmly. • To maintain smooth action, apply some grease-grade oil (ex. lithium grease) to all of the moving parts as needed. * Specifications and design are subject to change without notice. q Cymbal Support Plate To attach the bottom hi-hat cymbal first, remove the hi-hat clutch and set the bottom hi-hat cymbal on the rubber washer. At this time, make sure that the metal plate and the rubber washer are on the cymbal support plate. Rotate the knurled head bolt, located under the plate, to adjust the angle of the cymbal then secure with the fixing nut. Clutch Bolt Lock Nut Wing BoltDrum Key Bolt w Felt Clutch Nut Drum Key Bolt q e Memory Clamp After you have determined the height of the hi-hat cymbal, secure memory clamp at the base assembly’s pipe holder to set a “memory” of the pipe’s position for future settings. At this time, make sure the memory clamp fits into the pipe holder. Use a drum key to firmly tighten the memory clamp so as to prevent the pipe from slipping during performance. Also, the pipe holder is equipped with a drum key holder. (The drum key is optional.) Memory Clamp Pipe Holder r Spring Tension Adjustment The large adjustment dial adjusts spring tension. Turning the dial to the left increases tension while turning to the right decreases tension. Also, this system is equipped with a tension indicator that conveniently displays the amount of tension. t Connecting Connecting the rod y Spikes The spikes prevent the hi-hat stand from sliding The unit is equipped with four spikes, one in each of the front leg’s rubber feet and two on the frame. Spikes located in the legs rubber the drum key bolt. Those in the frame can be extended to the preferred length by rotating the bolts clockwise. u Adjusting Leg Position The position of the legs (footboard) can be adjusted by loosening bolts A and B, shown in the Leg diagram on the right. After the position has been determined, firmly tighten bolts A and B. Footboard (example: HS1100) i Adjust the Footboard Angle The angle adjuster can be used to increase or decrease the amount of footboard angle by raising or lowering the adjuster. With a drum key, loosen the two bolts on either side of the angle adjuster then slide the angle adjuster higher or lower as needed. After the angle has been determined, firmly tighten two bolts with a drum key. Bolt Angle Adjuster o Heel A removable rubber the rubber, reveals a strip of Velcro™ that, provides better grip when the stand is used on carpeted If the Velcro does not provide sufficient grip, use the rubber. !0 The Supplied Soft Case and To protect the hi-hat stand's finish from scratches, etc., werecommend that it be placed in the supplied soft case when transporting. Also, please wrap the upper pipe in the supplied sheet. !1 A protective sheet A protective sheet is applied to the HS1100 to protect the finish. Pr...

Download now

Please, enter two numbers from picture: