Votes - 3, Average rating: 4
(
)
)
|
Other manuals for this model:
manual abstract
14 Set up and Use ¦ Personal Studio™ ST9 Connecting Cable Stereo Earphones Handle (P. 17) PM3 for FRENCH HORN Lock Nut PM7 for TRUMPET PM6 for FLUGELHORN PM5 for TROMBONE PM9 for PICCOLO TRUMPET PM2 for EUPHONIUM Handle 15 Connecting Cable Stereo Earphones PM1 for TUBA Before connecting the cable and attaching the Pickup Mute™, make sure the power is switched OFF and the earphones are removed from your ears. Handle ¦ Assembling the PM1 Head Inner Head Body 1. Lay the Head on the floor. 2. Place the Body on the Head and fasten with the three hooks. 3. Fully extend the Inner Head that is located in the center of the Head. * Refer to pg.16 for instructions on attaching the Pickup Mute™ to the instrument. Hook Lock Nut 16 As shown in the illustration, hold the instrument with your left hand and, while turning the Pickup Mute™, firmly insert it into the bell with your right hand. Attaching and removing the Pickup Mute™ PM9/PM7/ PM6/PM5/PM3 For Euphoniums, with the bell facing up, hold the PM2 by its handle in your right hand and firmly insert it into the bell. ¦ Attach the Pickup Mute™ PM1 to the Tuba 1. After assembling the PM1 (refer to pg. 15) lay it on its side. While seated, hold the tuba between your legs. Hold the PM1 by its handle and lift it up. 2. Holding the PM1 with both hands, gently insert the Inner Head into the bell of the tuba. (Continue holding the tuba between your legs.) 3. Adjust the PM1 so that it is positioned in the center of the bell. * Noise will result if the Inner Head is touching the bell. 4. Attach the PM1 fixing hooks to the bell. If necessary, adjust the length (tension) of the hook belt. 5. Connect the lock nut equipped end of the supplied cable to the PM1’s output jack and secure the lock nut. After removing the PM1 from the instrument, lay the PM1 on its side. If the PM1 is stood vertically, the Inner Head will collapse causing a burst of noise in the earphones that may result in hearing impairments. When putting the PM1 away, hold the Inner Head with both hands and gently collapse it back into the Body. Strongly dropping the Inner Head may result in damage to the PM1. QUICK GUIDE Attaching the Pickup Mute™ to the Euphonium Holding the Pickup Mute™ when playing the horn standing up As shown in the illustration, lightly support the handle in the middle of the Pickup Mute™ with the ball of your thumb while holding the instrument at the bell rim with your other fingers.The handle also features a ring for a wrist band, allowing you to hang the Pickup Mute™ from your wrist (just like any other mute) while emptying the horn. (Wrist band is not included.) * Always remove the Pickup Mute™ before emptying the instrument. The following cautions are for your own safety and to avoid possible damage to and malfunctioning of the equipment, and thus should be observed carefully. . Firmly insert the Pickup Mute™ into the bell of the instr ument. . Avoid dropping the Pickup Mute™. Dropping the mute may result in damage.Also,shocktoth...
Other models in this manual:Musical Instruments - PM2 (636.33 kb)
Musical Instruments - PM3 (636.33 kb)
Musical Instruments - PM5 (636.33 kb)
Musical Instruments - PM6 (636.33 kb)