Votes - 3, Average rating: 3.7
(
)
)
|
manual abstract
M: Normal wah effect. L: Wah occurs on low notes, especially with an electric bass. Can also be used to give a milder sound to lead guitars. Width Control This knob is used to range. Rotate clockwise expands the effect and counterclockwise narrows it. Input Jack The input jack is used for connecting electric guitar and other electronic instruments. Output Jack The output jack is used for amplifier connection. AC Adaptor Jack This jack is for used with the adaptor (BOSS ACA). For long performances, AC should be used. Normal/Effect Selector Switch This pedal is used to switch the effect on and off. Effect Indicator An LED indicates normal/effect state and battery condition. When it effect is on. Replace batteries when LED becomes dim or does not light. Coin Screw The battery cover can be removed by loosening the screw. * Batteries must be replaced as a pair, (two 1.5V x 2) The electronic PW-1 uses hall devices to produce a powerful wah effect without click inherent in variable resistor types. Like the proven electronic switches used in the compact series, this system stands up to the severest use. Dual power supply (two 1.5V dry cells or AC) assures economical, convenient operation. -• Effect Indicator CONNECTING PW-1 OPERATING PW-1 TO AC ADAPTOR JACK AMPLIFIER GUITAR BOSS PW-1 BEFORE USING PW-1 • When operating PW-1 from AC line, use BOSS AC Adaptor for PW-1. • Avoid using PW-1 at very dusty location or under high temperature or humidity conditions. After connecting all cords required, set all knobs on the panel as illustrated. Step on the pedal's toe side to turn effect on. An LED lights to indicatethatthe effect is on and internal batteries are sufficiently charged. Set RANGE selector for the desired effect. Turn WIDTH control to. CAUTIONS FOR REPLACING AND HANDLING BATTERY BATTERY REPLACEMENT Two 1.5V dry cells are usad. O Open the cover by loosening the screw at the bottom of the pedal with a coin. 9 Remove old batteries from the battery case. 0 insert new batteries. Make sure polarity is correct. O Close the cover. Insert and tighten screw. Always replace batteries as a pair. CAUTIONS • When you don't use for a long period, remove the battery to prevent current leakage and leaking out of sticky substance. • If battery voltage drops, effect becomes inferior or no sound is produced. To prevent that, replace the battery a little earlier. • Batteries must be loaded in the battery box even if an AC adaptor is used. * Even if AC Adaptor cord comes out during performance, operation immediately changes to battery, causing no trouble in continued performance. • Power is switched on while a plug is put into input jack. When you do not use, keep the plug off the jack. SPECIFICATIONS Power............Battery DC 3V (1.5V x 2), AC adaptor Current draw........DC 3V, 50mA Controls...........Wah (pedal), Range change switch, Width Others............Normal/effect selector switch, Effect indicator (also used to check battery) Jacks.............Input, Output, AC adaptor input impedance............470kft Output load impedance , . Over 10ka Dimensions.........110(W) x 65(H) x 320{D)mm (4.3" x 2.6" x 12.' Weight............1.3kg (2.86 lbs.) * Specifications are subject to change without notice. AC ADAPTOR (OPTION) When you operate PW-1 from AC line, use AC Adaptor (DC9V) for PW-1. G BOSS Produd* of Roland Printed in Japan f^Rolancf 10429 UPC ...