Votes - 1, Average rating: 5
(
)
)
|
manual abstract
RRC Foot Pedal Mode ..........................................5 (RMC-1), the FC-1 OOmk H can be used as an all-purpose 2. MIDI Foot Peda! Mode..........................................5 MIDI foot controller, which provides pedal control over [¿j RRC Foot Pedal Mode .............................................6 transmission of any Program Change to a connected 1. Setup Examples ....................................................6 MIDI device. 2. Mode Setting.........................................................7 3. Operation...............................................................7 The FC-1 OOmk H allows you to make 3 whole range of a. Patch Selection ...................................................7 setting, including the MIDI channel, and Control Numbers b. Control Pedal......................................................8 for the ell-purpose pedal unit or expression pedal. c. Expression Pedal ................................................3 G0 MIDI Foot Pedal Mode.............................................9 Using MIDI messages {System Exclusive), the settings for, 1. Setup Examples .................................................. 9 and operation of each pedal can be individually controlled 2. Mode Settings..................................................... 10 from sn external MIDI device. a. MIDI Mix On/Off .............................................. 10 b. MIDI Channel ................................................... 10 c. OMNI On/Off.................................................... 10 d. Control Numbers .............................................. 10 3. Restoring the Factory Preset Data...................... 13 4. Operation............................................................. 14 a. Patch Selection................................................. 14 b. Control Pedal .................................................... 16 c. Expression Pedal .............................................. 16 02 Using Exclusive Messages .................................... 17 1. Concerning Modes .............................................. 17 2. About the RRC Mode.......................................... 18 [6] Reference ............................................................... 19 1. Table of data which can be edited ...................... 19 2. Factory Preset Data............................................. 19 3. Troubleshooting...................................................20 About Roland Exclusive Messages .........................21 MID! Implementation Chart.....................................25 MIDI Implementation ..............................................26 ■ SPECIFICATIONS....................................................30 m Copyright © 1988 by ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. IMPORTANT NOTES Concerning placement • Avoid using or storing the unit in the following places, as damages could result. o Places subject to extremes in temperature. (Such as under direct sunlight, near heating units, above equipment generating heat, etc.) o Places near water and moisture. (Baths, washrooms, wet floors, etc.) Places otherwise subject to high huidity. o Dusty environments. o Places where high levels of vibration are produced, f Maintenance • For everyday cleaning, wipe the unit with a soft dry cloth, or one that is dampened siightfy. To remove dirt that is more stubborn, wipe using a miid, neutral detergent. Afterwards, make sure to wipe throughly with a soft cloth. • Never apply benzene, thinners, alcohol or any like agents, to avoid the risk of discoloration and deformation. j Concerning memory backup j • Please be aware that the contents of memory may at times be lost; when sent for repairs or when by some chance a malfunction has occurred. Important data should be written down on paper. During repairs, due care is taken to avoid the toss of data, however, in certain cases, such as when circuitry related to memory itself is out of order, we regret that it may be impossible to restore the data. Ohter Precautions • Protect the unit from strong impact. • Avoid getting any foreign objects (coins, wire, etc.), or liquids (water, drinks, etc.) into the unit. • Before using the unit in a foreign country, check first with your local Rotand Service Station. • At any time that you notice a malfunction, or otherwise suspect there is damage, immediately refrain from using the unit. Then contact the store where bought, or the nearest Roland Service Station. In the event that your instrument must be returned for service, it should be returned together with the connection cable and the host unit. The problem may outside the unit. ¡J] Panel Descriptions «Rear Panel» 1 ^ « FOOT CONTROLLER HOland fcmdOmkH < > ■ ; ■ c >’ € }......... € « Front Panel»