Votes - 2, Average rating: 3.5 ( )

Manafacture: Crate Amplifiers File size: 727.79 kb File name: Language of manual:

9: LOW: Use this control to adjust the low frequency level of the Solo/Rhythm channel. 10: MID: Use this control to adjust the midrange frequency level of the Solo/Rhythm channel. 11: HIGH: Use this control to adjust the high frequency level of the Solo/Rhythm channel. 12: LEVEL: Use this control to adjust the output level of the Rhythm channel. 13: SOLO/RHYTHM/CLEAN SELECT: Use this switch to select the Clean channel or the Solo and Rhythm channels. With the switch in the out position, the Clean channel is selected. When the switch is depressed, either the Solo or Rhythm channel is selected, depending on the setting of the Solo/Rhythm switch (#6). CLEAN CHANNEL: A normal gain channel designed to give you crystal clean sounds. 14: CLEAN LED: This LED illuminates when the Clean channel is selected. 15: VOLUME: Use this control to adjust the output level of the Clean channel. 16: LOW: Use this control to adjust the low frequency level of the Clean channel. Guitar Amplifier Guitar Amplifier 20 2122 23 VOLUMELEVEL LOW MID HIGH POWER CD INPUT CLEAN RHYTHM / SOLO CLEAN REVERBREVERB SAVE / TAPSAVE / TAP VIBVIB OO DELAYDELAY EFXEFX ECHOECHO SINGLESINGLE TAPETAPE DSPDSP 12 15 16 17 18 252413 14 17: MID: Use this control to adjust the midrange frequency level of the Clean channel. 18: HIGH: Use this control to adjust the high frequency level of the Clean channel. 19: MULTI: Use this control to select one of the fifteen “Multi” digital effects. Complete information about the DSP effects is on page 7. 20: DELAY: Use this control to select one of the fifteen Delay digital effects. Complete information about the DSP effects is on page 7. 21: SAVE/TAP: Use this pushbutton to set the tempo of many of the effects by tapping the button repeatedly in time with the desired tempo. The Save/Tap button is also used to save DSP presets and to restore the factory default DSP settings. Additional information about the Save/Tap button is on pages 7 and 8. 22: SAVE/TAP LED: This LED flashes in time with the tempo set by the Save/Tap button (#21), and serves as a status indicator for certain DSP activities (see page 8). NOTE: For some of the DSP effects, the Save/Tap LED remains illuminated. The Save/Tap LED does not illuminate when the DSP knobs are set to the Bypass position. 23. REVERB: Use this control to adjust the amount of digital reverb effect. In its fully counterclockwise position the signal will be “dry” (without any reverb). As you rotate the control clockwise the amount of reverb increases. 24: CD INPUT: Use these RCA jacks to connect the output from a CD player or tape deck to the amplifier. The signal at these jacks is combined into a mono signal which is sent to the internal power amp circuit. Use the CD or tape player’s output level control to adjust the signal for the proper mix with your guitar. 25: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch dep...

Download now

Please, enter two numbers from picture: