Votes - 3, Average rating: 3.3 ( )

Manafacture: Dimplex File size: 122.73 kb File name: 7207980100r00.pdf Language of manual:

4. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 5. To disconnect the unit, turn the controls off, then remove the plug from the outlet. 6. Do not modify the electric fireplace. Use it only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons. 7. Do not burn wood or other materials in the electric fireplace. 8. Do not strike the fireplace glass. 9. Always use a certified electrician should new circuits or outlets be required. 10.Always use properly grounded, fused and GFI outlets. 11.Disconnect all power supply before performing any cleaning, maintenance or relocation of the unit. 12.Do not use a pressure washer to clean unit. 13. When transporting or storing the unit and cord, keep in a dry place, free from excessive vibration and store so as to avoid damage. NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, illness or death. Serial Number Model Number Serial Number MODEL AND SERIAL NUMBER INFORMATION If you have any questions regarding our products please have the product model and serial numbers available upon calling Dimplex customer service or technical support. To locate the model and serial number labels see below. Record the Model number, Serial number, and CAT number on the front cover of this manual for future reference. Model Number Model Number Serial Number Firebox Carton 2 Figure 1 NOTE 1 A 15amp, 120 volt outdoor GFI is required. Additional appliances on the same circuit may exceed the current rating of the circuit breaker. WARNING Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, electric shock or injury to persons. Construction and electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electric shock and injury to persons. Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to persons, always use a licensed electrician. SITE SELECTION AND PREPARATION This section provides instructions for selecting a location and preparing the site to install the fireplace into your Dimplex mantel surround. 1. Select a suitable location. 2. For ease of electrical hook up you may wish to locate the fireplace near an existing outlet. (refer to NOTE 1). NOTE The dimensions of the fireplace are 24.60”wide X 20.10” high X 8.40” deep. The viewing area is 23” wide and 13” high. 20 Feet Figure 2 FIREPLACE INSTALLATION 1. Install the fireplace assembly only into the Dimplex outdoor mantel. (refer to mantel assembly instructions) OPERATION ELECTRIC FIREPLACE MANUAL CONTROL The manual controls for the firebox are located in the upper right hand corner behind the access panel. To access the controls, open the upper access panel by pulling forward and down. To locate controls refer to Figure 3. A. Main On/Off Switch The ON/OFF SWITCH supplies power to the flames and over head lights. NOTE: This unit does not have a heat option. Figure 3 Main On/Off Switch MAINTENANCE WARNING Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. COVERING YOUR DIMPLEX OUTDOOR FIREPLACE When not in use, cover your Dimplex outdoor fireplace with a weather resistant covering. The cover will help protect your fireplace from detrimental effects of weather and enviromental pollutions. GLASS CLEANING The glass is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the glass may collect dust particles; these can be removed by dusting lightly with a clean dry cloth. To remove fingerprints or other marks, the glass can be cleaned with a damp cloth. To prevent scratching, do not use abrasive cleaners or spray liquids on the glass surface. SEASONAL CLEANING To clean the glass or remove debris from inside unit. NOTE: Gloves are required as edges may be sharp. 1. Remove top from mantel. 2. Lift firebox out of mantel. 3. Lay firebox on it’s back. 4. Remove screws from the left and right side of the front glass lower support. (Fig 4) 5. Insert the tip of a slot screwdriver between the glass edge on either the left or right side trim. 6. Using the screwdriver as a lever apply presure in a downward motion, forcing the edge of the glass up. Figure 4 ONE YEAR LIMITED WARRANTY Products to which this limited warranty applies This limited warranty applies to your newly purchased Dimplex electric fireplace and to ...

Download now

Please, enter two numbers from picture: