Using Current Indications During Locating Both the Transmitter and Receiver will indicate cable current. These current indications will help to select a trace frequency, identify the correct cable and trouble shoot the set up. When using the direct connect method, the Transmitter output current number is displayed. A "LO" display, or number less than 50, indicates a weak tracing signal. A number higher than 70 represents a strong tracing signal. When the Receiver is used to find the cable near t

2 Installing or Replacing the Batteries ........................................ 2 Initial Receiver Configuration .................................................. 3 Receiver Battery Test ................................................................ 3 Transmitter Battery Test ........................................................... 4 Using External DC Power and 5 Watt Output .......................... 4 Locating a Buried Cable ........................................................... 5

DANGER! Check for stray voltage before attaching Transmitter. Voltage greater than 240 volts will damage equipment and cause personal injury and death. Follow standard procedures for reducing the voltage. WARNING! Potential for electrical shock exists when handling connecting cables while the Transmitter is in the TRACE, FAULT or TONE modes. Turn the Transmitter off before handling connecting cables. Page 4 Direct Connect Method Make sure the Transmitter is off. Plug the direct connect cable int