Votes - 0, Average rating: 0
(
)
)
|
manual abstract
– Then select the desired function (PLAY, NEXT, etc.). 10 Untitled-13 10 OPERA TING THE SYSTEM Important: Before you operate the system, complete the preparation procedures. Demonstration mode The system has a demonstration mode that shows the various features offered by the system. When the system is switched on for the first time, the demonstration mode will start automatically. Notes: – During the demonstration, if you press any source (or standby-on) button, the system will switch to the respective mode (or standby). – When the system is switched to standby mode, the demonstration will resume 5 seconds later. 6/15/00, 1:15 PM SOUND NAVIGATION INCREDIBLE SURROUND DYNAMIC BASS BOOST TAPE CD PROG CLOCK/ TIMER DUB(HSD) REC SIDE A•B TUNER AUX PRESET ss STOP•CLEARSEARCH • TUNING PLAY PAUSE PREV NEXT MINI HIFI SYSTEM CD1 • 2 • 3 CDRBAND TAPE 1 • 2 FRONT 60Hz 500Hz250Hz 1KHz 2KHz 4KHz 8KHz VOLUME SHUFFLEPROGRAM DIGITAL SOUND CONTROL REPEAT A. REV STANDBY ON NEWS/TA RDS MIC MIC LEVEL T o stop the demonstration mode • Press and hold STOP•CLEAR . (on the system only) for 5 seconds when the system is in demonstration mode. . The demonstration will stop. . " DEMO OFF " is displayed. . The system will switch to standby mode. ™ (for FW555C only) About 5 seconds later, the system will go into an energy saving mode ( < 2 watts ). The low power STANDBY ON LED will be lit. Note: – Even though the AC power cord is removed from and reconnected to the wall socket, the demonstration will remain off until it is switched on again. 3139 116 18533 11 English 3139 116 18533 To start the demonstration mode • Press and hold STOP•CLEAR .(on the system only) for 5 seconds when the system is in standby mode. . The demonstration will begin. Easy Set EASY SET allows you to store all available radio stations and RDS stations automatically. 1 Press and hold STANDBY ON (on the system only) for 5 seconds; when the system is in standby or demonstration mode. . “EASY SET” will be displayed, and followed by “TUNER” and then “AUTO”. . EASY SET will start searching for all radio stations with RDS and then followed by radio stations on FM, MW and LW band respectively. . All available RDS and radio stations with sufficient signal strength will be stored. Up to 40 presets may be stored. 2 The system will proceed to set the RDS time automatically with the stored RDS preset station. • If no RDS station is available in the first preset station, the program will exit automatically. . After a radio station is found, “EASY SET” will be displayed and followed by “TIME” OPERATING THE SYSTEM • When searching RDS time; . “SEARCH RDS TIME” will be displayed. . When RDS time is read, “RDS TIME” will be displayed. The current time will be displayed for 2 seconds and stored automatically. Notes: – EASY SET will start with the RDS station, if there are still presets available, it will continue to store the FM, MW and LW bands respectively. – When EASY SET is used, all previously stored radio stations will be replaced. – The last preset radio station or the first available RDS station will appear on the display when EASY SET is completed. – If RDS station does not transmit RDS time within 90 seconds, the program will exit automatically and the display will show “NO RDS TIME”. Switching the system ON • Press CD, TUNER, TAPE or AUX. You can also switch on the system by pressing any one of the CD DIRECT PLAY buttons. Switching the system to standby mode • Press STANDBY ON again or B on the remote control. . The system will switch to standby mode. . (for FW555C only) About 5 seconds later, the system will go into an energy saving mode ( < 2 watts ). The low power STANDBY ON LED will be lit. Selecting the Source • Press the respective source selection button: CD, TUNER, TAPE or AUX. . The display indicates the selected source. Note: – For an external source, make sure you have connected the audio left and right OUT terminals of the external equipment (TV, VCR, Laser Disc player, DVD player or CD Recorder) to the AUX/CDR IN terminals. Selecting the Equalizer Display You can select the desired equalizer display for the system. You must not press the DSC or INCREDIBLE SURROUND button on the system before using the JOG. • Rotate the JOG to select the desired Equalizer Display, NORMAL, TOP DOWN, or NITE MODE. . The selected display will be shown. NORMAL Display FM FRONT STEREO BACK HSD REPEAT REC NEWS T.A. AMMW LW TIMER 60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz PROGRAMSHUFFLE TOP DOWN Display FM FRONT STEREO BACK HSD REPEAT REC NEWS T.A. AMMW LW TIMER 60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz PROGRAMSHUFFLE NITE MODE Display 60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz FM FRONT STEREO BACK HSD REPEAT REC NEWS T.A. AMMW LW TIMER PROGRAMSHUFFLE Note: – In NITE MODE, all lights will be switched off and the display brightness will be dimmed. Untitled-13 11 6/15/00, 1:15 PM English OPERATING THE SYSTEM Sound Control VOLUME ADJUSTMENT Adjust VOLUME to increase or decrease the sound level. For Perso...