Votes - 0, Average rating: 0
(
)
)
|
manual abstract
Allow at least 10cm clearance from the rear and the top of the unit and 5cm from the each side. • Do not expose the system to excessive moisture, rain, sand or heat sources. • Under no circumstances should you repair the system yourself, as this will invalidate the warranty! • If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the CD unit inside the system. Should this occur, the CD player will not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible. • Electrostatic discharge may cause unexpected problems. See whether these problems disappear if you unplug the AC power cord and plug it in again after a few seconds. • T o disconnect the system from the power supply completely , remove the AC power plug from the wall socket. English 3139 116 19551 pg 01-26/C55/22-Eng new 5 3/6/00, 11:42 AM PREPARATION English Rear Connections AM ANTENNA AC MAINS ~ A B H C FRONT G D AUDIO OUT L R L + – R – + FM ANTENNA 75 . L R L R HIGH POWER SUBWOOFER SUBWOOFER LEVELCONTROL STANDBY ON CUT OFF FREQUENCY 60Hz 150Hz MIN MAX E F AUDIO IN AUX/CDR IN SUB-WOOFER OUT LINE OUT DIGITAL OUT 3139 116 19551 pg 01-26/C55/22-Eng new 6 3/6/00, 11:42 AM PREPARATION English A AM Loop Antenna Connection Connect the supplied loop antenna to the AM ANTENNA terminal. Place the AM loop antenna far away from the system and adjust its position for the best reception. D Subwoofer Out Connection Connect the optional active subwoofer to the SUBWOOFER OUT terminal. The subwoofer reproduces just the low bass sound effect (e.g. explosions, the rumble of spaceships, etc.). Be sure to follow the instructions supplied with the subwoofer. F Digital Out Connection You can record the digital sound from the CD, through this output, on any audio equipment with digital input (e.g. CD Recorder, Digital Audio Tape (DAT) deck, Digital to Analog Converter and Digital Signal Processor). Inserting batteries into the Remote Control • Insert the batteries (Type R06 or AA) into the remote control as shown in the battery compartment. + - + • To avoid damage from possible battery Connect one end of the cinch cable (not B FM Wire Antenna E Line Out Connection (wireless supplied) to the DIGITAL OUT socket and Connection the other end to the audio equipment with ready) Connect the supplied FM wire antenna to digital input.When connecting the cinch You can connect the audio left and right the FM ANTENNA 75 W terminal. Adjust cable, make sure it is fully inserted. LINE OUT terminals to a optional CD the position of the FM antenna for the best leakage, remove dead batteries or Recorder ANALOGUE IN terminals. This reception. batteries that will not be used for a long allows you to record in an analogue format. G Connecting other time. For replacement, use type R06 or Outdoor Antenna equipment to your system You can also install additional optional AA batteries. For better FM stereo reception connect an front active speakers away from the You can connect the audio left and right outdoor FM antenna to the FM ANTENNA system (e.g. in another room) to reduce the OUT terminals of a TV, VCR, Laser Disc 75 W terminal using a 75 W coaxial wire. inconvenience of running long speaker player, DVD player or CD Recorder to the wires across rooms. You can place as many AUX/CDR IN terminals at the rear of the remote speakers as you like provided they system. C Speakers Connection • Connect the right speaker to Front operate at the same radio frequency. terminal R, with the colored wire to + Connect the wireless radio frequency H AC Power Supply and the black wire to - . transmitter to the LINE OUT terminals. After all other connections have been made, connect the AC power cord to the • Connect the left speaker to Front Place the active speakers at your preferred terminal L, with the colored wire to + location. Be sure to follow the instructions system and to the wall outlet. and the black wire to - . supplied with the active speakers. • Clip the stripped portion of the speaker Note: wire as shown. – Availability of wireless transmitter and 12 mm unlock lock its peripherals are subjected to the approval of local authorities. Please check with respective local safety or approving authority. 3139 116 19551 pg 01-26/C55/22-Eng new 7 3/6/00, 11:42 AM 8 English 3139 116 19551 CONTROLS STEREO FM BACK HSD REPEAT REC NEWS T.A. AMMW LW SOUND NAVIGATION DUB (HSD) REC 3CD CHANGER MINI HIFI SYSTEM TIMER FRONT 60Hz 250Hz 500Hz 1KHz 2KHz 4KHz 8KHz PROGRAMSHUFFLE INCREDIBLE SURROUND DYNAMIC BASS BOOST CD TAPE PROG CLOCK/ TIMER TUNER AUX PRESET s s SEARCH • TUNING STOP•CLEAR PLAY PAUSE PREV NEXT CD1 • 2 • 3 BAND TAPE 1 • 2 CDR/VIDEO DIGITAL SOUND CONTROL DISC CHANGE DISC 1 DISC 2 DISC 3 OPEN•CLOSE A. REV STANDBY ON NEWS/TA RDS SIDE MIC MIC LEVEL 1 2 ¤ . 3 4 5 6 9 8 7 0 ! @ # $ % ^ ( & . ) * . A . ° 2 1 2 3 . . . . . . . % . 8 3 . 2 ( . ( » ( ( U . @ . CD TAPE 1/2 TUN...