Votes - 3, Average rating: 4.3 ( )

Manafacture: Kenwood File size: 128.88 kb File name: Language of manual:

To AV control center Surround speakers Right Left White lined See-through Powered subwoofer To AC wall outlet NoteNote The shape of the speakers are variable depending on the system and marketing destination type. Operating instructions M-A300/A100 (En) 1 1 Switch the POWER key to ON position. POWER -ON .OFF Turn on the system by using the AV control 2center. • The power indicator on the panel lights up. 3 3 Play a music source. In case of difficulty What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see if the problem can be corrected before seeking help from your dealer or service representative. Symptom Cause Remedy Sound cannot be produced. (Indicator is off.) • The parallel cord is not connected. • The speaker cords are short-circuited. • The protection circuitry is activated due to internal temperature rise. • Connect them properly referring to “System connections”. • Turn the power OFF, remove the short-circuit, and turn the power ON again. • Switch the power OFF and wait for the internal temperature to drop. The unit can be turned ON and re-used when the temperature drops, but the fundamental solution of the problem is not possible unless the unit installation (heat radiation) condition is corrected. Improve the unit installation referring to page 4. Sound cannot be produced. (Indicator lights.) • The speaker cords are not connected. • Connect them properly referring to “System connections”. Sound is not produced from one of the speakers. • One of the speaker cord is not connected. • Connect it properly referring to “System connections”. Sound from the surround speaker is not produced or very low. • A speaker cord is not connected. • Connect it properly referring to “System connections”. NoteNote Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform the plastic components. Specifications Caution : Read this section carefully to ensure safe operation. M-A300 AUDIO section Effective output power during STEREO operation [Except for the U.S.A., Canada and the UK] 1kHz,10% T.H.D., at 6 W .......................................... 100 W + 100 W Rated output power during STEREO operation [For the U.S.A. and Canada] 100 watts per channel minimum RMS, both channels driven, at 6 W from 20 Hz to 20 kHz with no more than 0.09 % total harmonic distortion.(FTC) [For the UK] (DIN) 1 kHz, 0.7% at 6 W ......................................... 100 W + 100 W (IEC) 63 Hz ~ 12.5 kHz, 0.7% at 6 W ..................... 100 W + 100 W [For other countries] 1kHz,1% T.H.D.,at 6 W .................................................. 80 W + 80 W Effective output power during SURROUND operation [For the U.S.A., Canada and the UK] FRONT (1kHz, 5% T.H.D. at 6 W)........................ 100 W + 100 W CENTER (1kHz, 5% T.H.D. at 6 W)..................................... 100 W SURROUND (1kHz, 5% T.H.D. at 6 W) ............... 100 W + 100 W [For other countries] FRONT(1kHz, 10% T.H.D. at 6 W)....................... 100 W + 100 W CENTER (1kHz, 10% T.H.D. at 6 W)................................... 100 W SURROUND(1kHz, 10% T.H.D. at 6 W) .............. 100 W + 100 W Rated output power during SURROUND operation [For the U.S.A. and Canada] FRONT (1kHz, 1% T.H.D. at 6 W).............................60 W + 60 W CENTER (1kHz, 1% T.H.D. at 6 W)....................................... 60 W SURROUND (1kHz, 1% T.H.D. at 6 W)....................60 W + 60 W [For the UK] FRONT (1kHz, 1% T.H.D. at 6 W).............................50 W + 50 W CENTER (1kHz, 1% T.H.D. at 6 W)....................................... 50 W SURROUND (1kHz, 1% T.H.D. at 6 W)....................50 W + 50 W [For other countries] FRONT (1kHz, 1% T.H.D. at 6 W).............................55 W + 55 W CENTER (1kHz, 1% T.H.D. at 6 W)....................................... 55 W SURROUND (1kHz, 1% T.H.D. at 6 W)....................55 W + 55 W Total harmonic distortion ......................... 0.007%(1 kHz, 50W, 6 W) Frequency response LINE (FRONT, CENTER, SURROUND) ....................................................... 20 Hz ~ 70 kHz, +0 dB, –3 dB Signal to noise ratio (IHF’66) LINE ........................................................................................ 105 dB Input sensitivity / impedance LINE ................................................................................. 1 V / 47 kW GENERAL Power consumption [For the U.S.A. and Canada].......................................................4 A [Except for the U.S.A. and Canada] ..................................... 330 W AC outlet [For the U.S.A. and Canada] UNSWITCHED ................................. 1 (total 200 W, 1.6 A max.) [Except for the U.S.A. and Canada] UNSWITCHED ............................................ 1 (total 200 W max.) Dimensions....................................................... W : 400 mm (15-3/4") H : 140 mm (5-1/2")...

Download now

Please, enter two numbers from picture: