Votes - 1, Average rating: 5
(
)
)
|
manual abstract
NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS. THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. Declaration of Conformity with regard to the EMC Directive 2004/108/EC Manufacturer: Kenwood Corporation 2967-3 Ishikawa-machi, Hachioji-shi, Tokyo, 192-8525 Japan EU Representative's: Kenwood Electronics Europe BV Amsterdamseweg 37, 1422 AC UITHOORN, The Netherlands COMPACT Hi-Fi COMPONENT SYSTEM CAUTION for outdoor antenna installation Since antenna installation necessitates skill and experience, always consult your dealer before installation. The antenna should be placed at a distance from the power distribution wires. Otherwise, an electric shock accident may occur if the antenna falls down. Prepare the remote control Insert the batteries into the remote control by matching the polarity (+ and –) correctly. To insert the batteries in the remote control . Sound Mode To select the sound mode suitable for your favorite music Setting the clock You can set the clock only when the System is turned off (on standby.) 1 If you have already set the clock before, press and hold CLOCK/SLEEP until the clock is flashing. 2 Adjust the hour and minute. The clock may gain or lose 1 to 2 minutes per month. You may need to readjust the clock periodically. • • Maintenance To get the best performance of the System, keep your discs and the mechanism clean. Handling discs Remove the disc from its case by holding it at the edge while pressing the center hole lightly. Do not touch the shiny surface of the disc, or bend the disc. Put the disc back in its case after use. Be careful not to scratch the surface of the disc when placing it back in its case. Avoid exposure to direct sunlight, temperature extremes, and moisture. To clean the disc: Wipe the disc with a soft cloth in a straight line from center to edge. Cleaning the System Stains should be wiped off with a soft cloth. If the System is heavily stained, wipe it with a cloth soaked in water-diluted neutral detergent and wrung well, then wipe clean with a dry cloth. Since the System may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following: DO NOT wipe it hard. DO NOT wipe it with thinner or benzine. DO NOT apply any volatile substances such as insecticides to it. DO NOT allow any rubber or plastic to remain in contact for a long time. Cleaning the CD pickup lens Keep the CD pickup lens clean, or the sound may be degraded. Use a blower (available at a camera store, etc.) to blow dust off the lens. • • •• • • • ––– – • Supplied accessories After unpacking, check to make sure that you have all the following items: Remote control: RC-F0323E (. 1) R03 (UM-4)/AAA (24F)-size batteries (. 2) FM antenna (. 1) If anything is missing, consult your dealer immediately. . ••• R03(UM-4)/AAA(24F) CAUTION Store the battery in a place where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. To prevent the battery from overheating, cracking, or starting a fire: Do not recharge, short, disassemble or heat the battery or dispose of it in a fire. Do not leave the battery with other metallic materials. Do not poke the battery with tweezers or similar tools. Dispose of battery in the proper manner, according to federal, state, and local regulations. The battery (battery pack or battery installed) shall not be exposed to excessive heat source such as sunshine, fire or the like. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. • • – –– • • • Getting started To a wall outlet FM antenna (supplied): Extend it so that you can obtain the best reception. NOTE: Make sure the antenna conductors do not touch any other terminals, connecting cords or the power cord. Also, keep the antenna away from metallic parts of the System, connecting cords, and the AC power cord. Otherwise, it could cause poor reception. • Sound and other adjustments Connections Do not connect the AC power cord until all other connections have been made. In this manual... The remote control buttons are used for explaining the operations unless mentioned otherwise. However, if the System has the same or similar button names, they can also be used for the operations. “File” and “track” are used interchangeably. • • Amplifier section Output Power: 5 W + 5 W at 4 . (10% THD) Speakers/Impedance: 4 . – 8 . Audio Input: AUDIO IN: Stereo mini (o 3.5 mm) 250 mV/50 k. Digital input: USB MEMORY Tuner FM tuning range: 87.50 MHz – 108.00 MHz Disc player ...