Votes - 4, Average rating: 4
(
)
)
|
manual abstract
A B Poseidon 2 4.5 Start and stop of the machine (when connected to a water supply) 4.6 Start the machine (when connected to open containers (suction mode)) 4.7 Pressure regulation on the Flexopower Plus- spray lance The spray lance is affected by a thrust during operation - therefore always hold it firmly with both hands. IMPORTANT: Point the nozzle at the ground. 1. Check that the machine is in upright position. NOTE: Do not place the machine in tall grass! 2. Release the trigger lock. 3. Activate the trigger of the spray handle and let the water run until all air has escaped from the water hose. 4. Turn the start/stop switch (1) to position "I". 5. Activate the trigger of the spray handle. Always adjust the distance and thus the pressure of the nozzle to the surface, which is to be cleaned. The washer can take in water from a rain water tank as an example. The hose for the water supply must not be too long, approx. 5 m. Make sure that the water tank is not placed on a lower level than the machine. Use an external filter if the water contains impurities. 1. Make sure that the water hose is filled completely with water before connecting to the machine. Place the entire Do not cover the machine during operation. Note: If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O" (1): 1. Turn the start/stop switch to position "O". 2. Disconnect the electrical plug from the socket. 3. Shut off the water supply and activate the trigger to relieve the machine of pressure. 4. Lock the spray handle. When releasing the trigger of the spray handle, the machine automatically stops. The machine will start again when you re-activate the spray handle. hose in a tank or bucket. To avoid water spillage, crimp the water inlet hose down in the water and then connect the hose to the machine with the quick coupling and fi nally uncrimp the water inlet hose. 2. Dismount spray handle, lance and nozzle. 3. Turn the start/stop switch to position "I" and let the water run, until the air has escaped from the water hose and the pump. 4. Mount spray handle, lance and nozzle again. The pressure can be regulated on the Flexopower Plus spray lance. High pressure Low pressure 68 Original Instructions 69 Poseidon 2 Original Instructions 4.8 Operation with detergents Application of detergents is NOT possible if an extension hose is applied. 1. Fill the container with a detergent. 2. Mount the Flexopower Plus spray lance and adjust it to low pressure (see section 4.7). 3. Adjust the dosing regulator (12) to the re quired vol ume of detergent (0-5%). 4. Apply the detergent from below and up wards. 5. Let the detergent act for the time stated on the packing of the detergent and fl ush with pure water. Separate detergent container 1. Remove the cover with suction hose from the detergent container. 2. Mount the cover with suction hose on the separate detergent container. The cover has a standard thread and fi ts common detergent containers. If your container does not have a standard thread, detach the fi lter from the suction hose and remove the cover. Remount the fi lter in the suction hose. Extra detergent hose can be pulled out of the machine. 4.9 Regulation of pressure / water volume Working pressure and water volume can be regulated on the machine by turning the button for regulation of pressure / water volume (6). Poseidon 2 5 Fields of application and working methods 5.1 General Efficient high pressure cleaning is achieved by following a few guidelines, combined with your own personal experience of specifi c cleaning tasks. Accessories and detergents, when correctly chosen, can increase the efficiency of your pressure washer. Here is some basic information about cleaning. 5.1.1 Detergent and foam Foam or detergent should be applied onto dry surfaces so that the chemical product is in direct contact with the dirt. Detergents are applied from bottom to top, for example on a car bodywork, in order to avoid "super clean" areas, where the detergent collects in higher concentration and streams downwards. Let the detergent work for several minutes before rinsing but never let it dry on the surface being cleaned. Note: It is important that the detergents do not dry up. Otherwise the surfac that has to be cleaned can be da maged. 5.1.2 Mechanical effect In order to break down tough layers of dirt, additional mechanical effect may be required. Special wash brushes offer this supplementary effect that cuts through dirt (especially by car washing). 70 Original Instructions 71 Poseidon 2 Original Instructions . 6 After using your pressure washer 6.2 Winding up of electric cable and high pressure hose up carefully. 1. Wind up the electric cable on the appropriate hooks. Builtin clip for good holding. The lower hook can be turned to release the electric cable. 2. The high pressure washer comes in two models: A) with hook for storage of high pressure hose (14) - B) with a hose reel (13). 6.1 Storing the washer T...